Using the remote control
The remote uses two (2) provided AAA batteries. They are easily installed by sliding the cover off the remote's back, aligning the + and - ends of the batteries, sliding them into place, and then replacing the cover.
To operate, point the remote at the projection screen or at the projector (not at the computer). The range of optimum operation is about 30 feet (9.14m).
LED |
| |
navigation buttons | laser | |
button | ||
|
To use the laser pointer, press and hold the Laser button. The laser turns off when the button is released, or times out after two (2) minutes of continu- ous operation.
WARNING: Do not look into the laser beam emitted from the top of the remote control.
The remote contains four Source buttons that allow you to assign a particu- lar input to a specific source. Simply press the numbered Source buttons to travel to whatever four sources you wish to have available.
Press the remote's Menu button to open the projector's menu system. Use the arrow buttons to navigate, and the Select button to select features and
source buttons 
Troubleshooting the remote
backlight button
adjust values in the menus.
The remote also has a power button to turn the projector on and off, volume buttons and a mute button to control the sound, a backlight button to light the remote's buttons in the dark, and a video and computer button to switch between those two sources.
Two
The Auto Image button reacquires the computer image and the Presets but- ton lets you customize the settings for each source. Up to three Preset set- tings can be customized and saved.
•Make sure the batteries are installed in the proper orientation and are not dead. The LED at the top of the remote lights when any button is pressed when the battery power is adequate.
•Make sure you’re pointing the remote at the projector, not the com- puter, and are within the remote range of 30 feet (9.14m).
•If you are trying to control your computer’s mouse, make sure a mouse cable is connected. If using a the USB cable that is part of the M1 cable, make sure the correct drivers are installed.
27