InFocus LP260 manual Display

Page 41

Display

This feature allows you to turn the on-screen displays on and off. Select “On1” to show all displays, select “On2” to show all dis- plays except the Preparation screen, select “Off” to turn off all displays.

Ceiling

When you turn Ceiling on, the projector turns the image upside down for ceiling-mounted projection.

Rear

When you turn Rear on, the projector reverses the image so you can project from behind a translucent screen.

Power Management

This feature preserves lamp life by automatically turning the lamp off after no signal has been detected for five minutes.

1When the input signal is interrupted, the message “No signal” appears with a counter that starts at 5 and counts down to 0.

2After the counter reaches 0, the lamp is turned off, the Ready indicator turns off, and the fans run for 90 seconds. During this cool down time, the lamp cannot be turned on.

3After 90 seconds, the Ready indicator blinks and the lamp can be turned back on.

The lamp is automatically turned on when the input signal is re-connected or any button on the remote or keypad is pressed.

Lamp Age

This allows you to reset the lamp monitor replacement timer. See page 38 for details.

NOTE: The Power Management

feature is On by default.

33

Image 41

Contents I D E Page Safety Certifications Declaration of Conformity Table of Contents B l e N t e n t s Safety Instructions F e t y S t r u c t i o n s Introduction Image ResolutionCompatibility Unpacking the ProjectorT r o d u c t i o n Views of the projector If You Need Assistance WarrantyUsage Guidelines Image Size, Width and Height Setting UP the ProjectorVideo Pb ⁄ Cb Pr ⁄ Cr Reset audio OUT AV Connecting a Computer Connecting a Video Player Powering up the Projector and Adjusting the Image Turning Off the Projector Adjusting the Image Using the ProjectorI n g O j e c t o r Using the Remote Control Remote control Using the Keypad and Remote Buttons Source keypad only or Computer and Video remote only Computer menus Using the On-Screen MenusSystem Menu Computer AdjustmentsPC Adjustment Number of vertical lines Display area Image Menu See page 22 for instructions on setting these manually Position menu Screen menu Video Source menu Video AdjustmentsVideo System menu Component Video Signal Format Normal video image size with 4x3 aspect ratio Color Sharpness Setting menu Display Language menu Cleaning the Fan Intake Filters Maintenance & TroubleshootingCleaning the Lens Replacing the Projection Lamp Removing the lamp cover Replacing the Batteries in the Remote Control Problem Only the start-up screen displays Troubleshooting Problem The projector is not runningProblem The screen resolution is not right Problem Color or text not being projectedProblem Image isn’t centered on the screen Problem Image is too wide or narrow for screenProblem Image is noisy or streaked Problem no soundProblem Lamp seems to be getting dimmer Problem Lamp shuts offI n t e n a n c e Troubleshooting Appendix SpecificationsStandard Accessories Ship with the projector Part Number AccessoriesOptional Accessories Key command to Computer Activate port De-activate port Portable and Laptop Activation ChartFN-F6 FN-F4 FN-F8 NCR Zeos Ctrl-Shift-D Using Video Mirroring with a PowerBook Computer P e n d i Hdtv IndexD e Limited Warranty Limitation of Liability