MAINTENANCE & TROUBLESHOOTING
This section describes how to:
•clean the lens
•clean the air filter
•replace the projection lamp
•replace the batteries in the remote
•troubleshoot the projector
Cleaning the Lens
Follow these steps to clean the projection lens:
1Apply a
•Avoid using an excessive amount of cleaner, and don’t apply the cleaner directly to the lens.
•Abrasive cleaners, solvents or other harsh chemicals might scratch the lens.
2Lightly wipe the cleaning cloth over the lens in a circular motion.
3If you don’t intend to use the projector immediately, replace the lens cap.
Cleaning the Fan Intake Filters
The fan intake filters on the bottom of the projector catch dust and particles in the air. If the filters become clogged, the projector does not cool properly and may malfunction. To prevent this, clean the filters after every 100 hours of use.
1Turn off the projector and unplug the power cord.
2Turn the projector upside down and remove the two filters by pulling the latches up.
35