InFocus LP260 manual Powering up the Projector and Adjusting the Image

Page 17

Powering up the Projector and Adjusting the Image

1Remove the lens cap.

2Plug the power cord into the side of the projector, then plug it into your electrical outlet. A surge-protected power strip is recommended.

•The Ready indicator on top of the projector lights green, indicating the projector is ready to be turned on, and the Lamp indicator lights red.

3Press the power button on the top of the projector or on the remote.

•The fans start to run, the Lamp indicator dims, and the Preparation screen appears. This screen counts down from 30 seconds, then the image from the active source appears.

4If you connected a video player, turn it on.

•The video image should display on the projection screen. If a computer source is active, press the source button on the keypad (page 16) or the video button on the remote to dis- play your video image.

•Use the volume buttons on the remote to adjust the volume. The volume dialog box, showing the current volume level and mute status, appears for 4 seconds.

NOTE: Always use the power cord that shipped with the projector.

NOTE: The first time you connect your computer to the projector, the computer may display a message stating that new hardware was found. The Add New Hardware Wizard may appear. Use the Wiz- ard to load the correct driver (the computer considers the projector a Plug and Play Monitor).

9

Image 17

Contents I D E Page Safety Certifications Declaration of Conformity Table of Contents B l e N t e n t s Safety Instructions F e t y S t r u c t i o n s Introduction Image ResolutionCompatibility Unpacking the ProjectorT r o d u c t i o n Views of the projector If You Need Assistance WarrantyUsage Guidelines Image Size, Width and Height Setting UP the ProjectorVideo Pb ⁄ Cb Pr ⁄ Cr Reset audio OUT AV Connecting a Computer Connecting a Video Player Powering up the Projector and Adjusting the Image Turning Off the Projector Adjusting the Image Using the ProjectorI n g O j e c t o r Using the Remote Control Remote control Using the Keypad and Remote Buttons Source keypad only or Computer and Video remote only Computer menus Using the On-Screen MenusSystem Menu Computer AdjustmentsPC Adjustment Number of vertical lines Display area Image Menu See page 22 for instructions on setting these manually Position menu Screen menu Video Source menu Video AdjustmentsVideo System menu Component Video Signal Format Normal video image size with 4x3 aspect ratio Color Sharpness Setting menu Display Language menu Cleaning the Fan Intake Filters Maintenance & TroubleshootingCleaning the Lens Replacing the Projection Lamp Removing the lamp cover Replacing the Batteries in the Remote Control Problem Only the start-up screen displays Troubleshooting Problem The projector is not runningProblem The screen resolution is not right Problem Color or text not being projectedProblem Image isn’t centered on the screen Problem Image is too wide or narrow for screenProblem Image is noisy or streaked Problem no soundProblem Lamp seems to be getting dimmer Problem Lamp shuts offI n t e n a n c e Troubleshooting Appendix SpecificationsStandard Accessories Ship with the projector Part Number AccessoriesOptional Accessories Key command to Computer Activate port De-activate port Portable and Laptop Activation ChartFN-F6 FN-F4 FN-F8 NCR Zeos Ctrl-Shift-D Using Video Mirroring with a PowerBook Computer P e n d i Hdtv IndexD e Limited Warranty Limitation of Liability