IBM Partner Pavilion 6823, 6343, 6793, 6349, 6791, 6790, 6792, 6795, 6825, 6350, 2292 Installing a drive

Page 47

Notes:

1.Drives that are greater than 41.3 mm (1.6 in.) high cannot be installed.

2.Install removable media (tape or CD) drives in the accessible bay: bay 1 or 2.

Installing a drive

To install an internal drive, follow these steps.

1.Remove the cover. See “Removing the cover” on page 29.

2.If your computer has a CD drive or DVD drive, you might need to remove the signal and power cables from the drive.

3.If the drive you are installing is a removable-media drive, remove the bay panel from the front bezel.

4.Remove the metal shield from the drive bay by inserting a flat–blade screwdriver into one of the slots and gently prying it loose.

5.Pivot the drive bay latch handle toward the front of the computer and then pivot the drive bay cage upward, as shown, until it is latched in the up right position.

6.Make sure the drive that you are installing is set correctly as either a master or a slave device.

v If it is a hard disk drive, set as a slave device.

Chapter 4. Installing internal options — desktop model 35

Image 47

Contents Page Page Page Page Contents Index To connect To disconnect Safety InformationModem safety information Lithium battery noticeConsignes de sécurité relatives au modem Laser compliance statementViii User Guide How this book is organized About this bookInformation resources Identifying your computer OverviewUser Guide Microprocessor FeaturesExpansion Physical specifications small desktop model SpecificationsPhysical specifications desktop model Physical specifications microtower model Handling static-sensitive devices Available optionsTools required Overview User Guide Locating the connectors on the front of your computer Installing external optionsUSB connector Locating the connectors on the rear of your computer User Guide Installing external options Obtaining device drivers Connector DescriptionRemoving the cover Installing internal options small desktop modelIdentifying parts on the system board Locating componentsInstalling DIMMs Installing memoryWhat to do next Installing adaptersInstalling internal options small desktop model What to do next Drive specifications Installing internal drivesInstalling a drive Installing a Rope Clip Replacing the cover and connecting the cables Installing internal options small desktop model User Guide Installing internal options desktop model Locating components Installing internal options desktop model Installing adapters Installing internal drives Drive specifications Installing a drive To connect the first IDE CD drive or DVD drive To connect an additional IDE CD drive or DVD drive Replacing the cover and connecting the cables Installing internal options desktop model User Guide Installing internal options microtower model Moving the power supply Installing internal options microtower model Installing memory Installing adapters User Guide Installing internal drives Installing a drive Installing internal options microtower model To connect the first IDE CD drive or DVD drive Installing a Rope Clip Replacing the cover and connecting the cables Installing internal options microtower model User Guide Using the IBM Setup Utility program Erasing a lost or forgotten password clearing Cmos Administrator passwordSetting, changing, and deleting a password Changing the startup sequence Using Security Profile by DeviceOther settings in the IBM Setup Utility program Startup sequenceUser Guide Appendix A. Changing the battery User Guide System programs Recovering from a POST/BIOS update failureAppendix B. Updating System Programs User Guide Address map Appendix C. System address mapsSystem memory map LPT3 COM1 DMA I/O address mapAddress hex Description Bits Byte pointer Following tables list the IRQ and DMA channel assignments User Guide Television output notice Appendix E. Notices and trademarksIBM TrademarksDMA IRQ IndexLocation 19, 31 Memory Page Part Number 25P4024