IBM Partner Pavilion 6792, 6343, 6793 Specifications, Physical specifications small desktop model

Page 17

vPC DOS

Specifications

This section lists the physical specifications for your computer.

Physical specifications — small desktop model

Dimensions

Height: 104 mm (4.1 in.)

Width: 360 mm (14.2 in.)

Depth: 412 mm (16.2 in.)

Weight

Minimum configuration as shipped: 8.1 kg (18 lb)

Maximum configuration: 9.1 kg (20 lb)

Environment

Air temperature:

System on: 10° to 35° C (50° to 95° F)

System off: 10° to 43° C (50° to 110° F)

Maximum altitude: 2134 m (7000 ft)

Note: The maximum altitude, 2134 m (7000 ft), is the maximum altitude at which the specified air temperatures apply. At higher altitudes, the maximum air temperatures are lower than those specified.

Humidity:

System on: 8% to 80%

System off: 8% to 80%

Electrical input

Input voltage:

Low range:

Minimum: 90 V ac

Maximum: 137 V ac

Input frequency range: 57–63 Hz

Voltage switch setting: 115 V ac

High range:

Minimum: 180 V ac

Maximum: 265 V ac

Input frequency range: 47–53 Hz

Voltage switch setting: 230 V ac

Input kilovolt-amperes (kVA) (approximate):

Minimum configuration as shipped: 0.08 kVA

Maximum configuration: 0.30 kVA

Note: Power consumption and heat output vary depending on the number and type of optional features installed and the power-management optional features in use.

Heat output (approximate) in British thermal units (Btu) per hour:

Minimum configuration: 257 Btu/hr (75 watts)

Maximum configuration: 686 Btu/hr (200 watts)

Airflow

Approximately 0.45 cubic meters every three minutes (16 cubic feet every three minutes) maximum

Acoustical noise-emission values

Average sound-pressure levels:

At operator position:

Idle: 38 dBA

Operating: 43 dBA

At bystander position - 1 meter (3.3 ft):

Idle: 33 dBA

Operating: 37 dBA

Declared (upper limit) sound-power levels:

Idle: 3.75 bels

Operating: 4.99 bels

Note: These levels were measured in controlled acoustical environments according to the procedures specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO 9296. Actual sound-pressure levels in a given location might exceed the average values stated because of room reflections and other nearby noise sources. The declared sound-power levels indicate an upper limit, below which a large number of computers will operate.

Note: The computer is classified as a Class A or Class B digital device. See the Quick Reference for further information about this classification.

Chapter 1. Overview 5

Image 17
Contents Page Page Page Page Contents Index To connect To disconnect Safety InformationModem safety information Lithium battery noticeConsignes de sécurité relatives au modem Laser compliance statementViii User Guide How this book is organized About this bookInformation resources Identifying your computer OverviewUser Guide Microprocessor FeaturesExpansion Physical specifications small desktop model SpecificationsPhysical specifications desktop model Physical specifications microtower model Handling static-sensitive devices Available optionsTools required Overview User Guide Locating the connectors on the front of your computer Installing external optionsUSB connector Locating the connectors on the rear of your computer User Guide Installing external options Obtaining device drivers Connector DescriptionRemoving the cover Installing internal options small desktop modelIdentifying parts on the system board Locating componentsInstalling DIMMs Installing memoryWhat to do next Installing adaptersInstalling internal options small desktop model What to do next Drive specifications Installing internal drivesInstalling a drive Installing a Rope Clip Replacing the cover and connecting the cables Installing internal options small desktop model User Guide Installing internal options desktop model Locating components Installing internal options desktop model Installing adapters Installing internal drives Drive specifications Installing a drive To connect the first IDE CD drive or DVD drive To connect an additional IDE CD drive or DVD drive Replacing the cover and connecting the cables Installing internal options desktop model User Guide Installing internal options microtower model Moving the power supply Installing internal options microtower model Installing memory Installing adapters User Guide Installing internal drives Installing a drive Installing internal options microtower model To connect the first IDE CD drive or DVD drive Installing a Rope Clip Replacing the cover and connecting the cables Installing internal options microtower model User Guide Using the IBM Setup Utility program Erasing a lost or forgotten password clearing Cmos Administrator passwordSetting, changing, and deleting a password Other settings in the IBM Setup Utility program Using Security Profile by DeviceStartup sequence Changing the startup sequenceUser Guide Appendix A. Changing the battery User Guide System programs Recovering from a POST/BIOS update failureAppendix B. Updating System Programs User Guide Address map Appendix C. System address mapsSystem memory map LPT3 COM1 DMA I/O address mapAddress hex Description Bits Byte pointer Following tables list the IRQ and DMA channel assignments User Guide Television output notice Appendix E. Notices and trademarksIBM TrademarksDMA IRQ IndexLocation 19, 31 Memory Page Part Number 25P4024