Hasselblad Flextight 848 manual Operating Instructions

Page 15

Hardware Reference - Flextight 848

15

Operating Instructions

 

Operating Instructions

(See Figure 4 opposite).

1.It is assumed that the scanner and FlexColor software have been properly installed.

2.If not already done, turn the feed table (A) to normal position.

3.Press the red power button (F) on the front of the scanner to switch it on. The green light (G) starts flashing. This means that no firmware has been downloaded yet. It will be downloaded automatically later when you first run the FlexColor program.

4.Turn on your computer and start the FlexColor program. The green light (G) will stop flashing indicating that firmware has been downloaded to the scanner.

5.Select the original holder (K) that matches your original:

For transparencies, choose one of the holders that has a square hole in it. The original must completely fill the hole with no edges showing. Also, no edges of the original must extend past the outer edges of the holder.

The feed table (A) must be in normal position.

For reflectives, select the large A4/letter-size holder with the clear plastic layer.

The feed table (A) must be in normal position.

For 35 mm slide frames use the optional 35 mm slide mount holder.

The feed table (A) must be adjusted to horizontal position. This is obtained by lifting the table slightly upwards while pushing it gently into the scanner.

Please note that when scanning 35 mm slide frames in the 35 mm slide mount holder it is recommended to use autofocus. See the FlexColor Software Reference for details.

continues...

English

User's Guide - Flextight 848

Image 15
Contents Users Guide Users Guide Flextight Table of Contents English Hardware Reference Flextight English System Requirements Hardware Reference Flextight Users Guide Flextight Front Panel Front panel features of FlextightBack panel features of Flextight Back Panel & ConnectorsCut-away view of Flextight Cut-Away ViewSetting up the Scanner Environmental RequirementsElectrical Requirements Installation Procedure, FireWire Interface Operating the Flextight 848 scanner Operating Instructions English English Reflective holder, top Resolutions True ResolutionsOriginal Max. resolution ppi At full scanning width Calibrating the Scanner Use procedure below to make Focus Calibration Select Focus Calibration from the Maintenance menuFocus Calibration White Calibration for Reflectives Use procedure below to make White CalibrationAlign the top edge Replacing the Light Tubes Replacing the Light Tubes Follow procedure below to replace a tubeLight Tubes GeneralEnglish Disposal Cleaning the External Surface of the ScannerTechnical Specifications FCC Notice Declaration of conformity CE Declaration of conformity