Hasselblad Flextight 848 manual Cleaning the External Surface of the Scanner, Disposal

Page 27

Hardware Reference - Flextight 848

27

Cleaning the External Surface of the Scanner

 

...continued

8.Remove the defective tube:

Press the flaps backwards to release the tube.

Pull the tube gently out of the holders and then sideways out of the scanner.

9.Insert the replacement tube and mount it into the holders making sure that it is properly held in place by the flaps.

10.Connect the plug (F).

11.IMPORTANT: The "T" on the lamp board cover (G) indicates the socket for the transparencies tube.

12.Lower the feed table (E).

13.Mount the side panels (C) and (D), the screws (B) and the front panel (A) following the reverse of the procedure used when removing them.

NOTE! When mounting the front panel (A) make sure to give it a firm push at the bottom to click it properly into position.

14.Turn on the scanner and check function of the new tube.

English

Cleaning the External Surface of the Scanner

If the external surface of the scanner becomes dirty, then clean it with a damp cloth. Be careful not to get any moisture inside the scanner or on any of the connectors. Do not use alcohol or other solvents.

Disposal

If you need to dispose of the scanner, it must be delivered to an authorized waste plant for electronics equipment.

User's Guide - Flextight 848

Image 27
Contents Users Guide Users Guide Flextight Table of Contents English Hardware Reference Flextight English System Requirements Hardware Reference Flextight Users Guide Flextight Front Panel Front panel features of FlextightBack panel features of Flextight Back Panel & ConnectorsCut-away view of Flextight Cut-Away ViewSetting up the Scanner Environmental RequirementsElectrical Requirements Installation Procedure, FireWire Interface Operating the Flextight 848 scanner Operating Instructions English English Reflective holder, top Resolutions True ResolutionsOriginal Max. resolution ppi At full scanning width Calibrating the Scanner Use procedure below to make Focus Calibration Select Focus Calibration from the Maintenance menuFocus Calibration White Calibration for Reflectives Use procedure below to make White CalibrationAlign the top edge Replacing the Light Tubes Replacing the Light Tubes Follow procedure below to replace a tubeLight Tubes GeneralEnglish Disposal Cleaning the External Surface of the ScannerTechnical Specifications FCC Notice Declaration of conformity CE Declaration of conformity