18 | Hardware Reference - Flextight 848 | |
Operating Instructions | ||
|
...continued
English
9.Lay the top layer of the holder down flat over the original.
•For transparency holders, the top layer is magnetic, which will hold the original fast.
•For the reflective holder, note the four metal pegs (the top two are shown as A and C in Figure 5 below); make sure that the clear plastic sheet is pressed all the way down over all four pegs. Note also the two curved tabs at the top of the holder (B in the figure below); the clear sheet must slip under each of these tabs, as shown.
A
B
C
Figure 5: Reflective holder, top
10.Go to your computer and follow the directions given in the FlexColor software manual to take a preview, make settings, and take the final scan.