Hasselblad Flextight 848 manual Front Panel, Front panel features of Flextight

Page 9

Hardware Reference - Flextight 848

9

Front Panel

 

Front Panel

A

D

 

 

E

 

F

B

G

C

H

Figure 1: Front panel features of Flextight 848

 

AFeed Table: must be in lower position for normal scanning. When scanner is not in use you can turn it to upright position flushing with the scanner front to protect it from dust etc. Adjust to horizontal position when using the 35 mm slide mount holder (see page 15).

BLight Table: for viewing originals. The grid helps you to align your transparent originals.

CTransparency Holder Guide: all transparency holders fit between two rails to keep them straight.

DOriginal Holder Clasp: all original holders slide into a slot here and are held in place by a magnetic clasp.

EPower Switch: press here to turn the unit on/off.

FPower Indicator (Green): Remains lit when ready to scan. Flashes when first installed to indicate that firmware must be loaded (it will be loaded automatically when you run FlexColor).

GMotor Drive Indicator (Yellow): lights when the scanner is repositioning the optics to scan in a new format or when drum is repositioning.

HScan Indicator (Red): lights when scanning. Do not touch the scanner while this indicator is lit. If the light is flashing when not scanning, then an error has occurred - please contact your Flextight dealer for assistance.

English

User's Guide - Flextight 848

Image 9
Contents Users Guide Users Guide Flextight Table of Contents English Hardware Reference Flextight English System Requirements Hardware Reference Flextight Users Guide Flextight Front Panel Front panel features of FlextightBack panel features of Flextight Back Panel & ConnectorsCut-away view of Flextight Cut-Away ViewSetting up the Scanner Environmental RequirementsElectrical Requirements Installation Procedure, FireWire Interface Operating the Flextight 848 scanner Operating Instructions English English Reflective holder, top Resolutions True ResolutionsOriginal Max. resolution ppi At full scanning width Calibrating the Scanner Use procedure below to make Focus Calibration Select Focus Calibration from the Maintenance menuFocus Calibration White Calibration for Reflectives Use procedure below to make White CalibrationAlign the top edge Replacing the Light Tubes Light Tubes Follow procedure below to replace a tubeGeneral Replacing the Light TubesEnglish Disposal Cleaning the External Surface of the ScannerTechnical Specifications FCC Notice Declaration of conformity CE Declaration of conformity