Configration

– Remote Control

Wireless: Set to use the included remote controller.

Standard 1

Picture Adjust

Fine Menu 1

Fine Menu 2

Input Signal

RGB/HD Adjust

Display

OSD/Blanking

Config.

Auto Power Off		Enable
Trigger 2	Full	On
Trigger 2	Normal	On
Trigger 2	Zoom	On
Trigger 2 Through		On
Remote Control

Color Temp.Calibration

Reset Lamp Life

Reset All

Wired:	Set to control the projector from either Marantz’s AV components connected to the
	REMOTE CONTROL IN/OUT terminals or a PC or other device connected to the RS-
	232C terminal of the projector. The included remote controller cannot be used in this case.

When this item is selected, a confirmation message appears asking whether to change the currently selected mode to the other mode or not. To change the mode, select “Yes” and press the ENTER button on the projector. To keep the same mode, select ‘No” and press the ENTER button.

Notes:

-To prevent misoperation, the ENTER button of the remote controller does not respond to touch when the Wired/Wireless setting is displayed. Press the ENTER button of the projector to enter the setting.

-To change from Wired to Wireless, set “Wireless” from the menu using the buttons of the projector.

ENGLISH

Item		Adjustments
Auto Power Off		Enable, Disable
Trigger 2 Full		On, Off
Trigger 2	Normal	On, Off
Trigger 2	Zoom	On, Off
Trigger 2	Through	On, Off
Remote Control		Wireless, Wired
Color Temp. Calibration		Yes, No
Reset Lamp Life		Yes, No
Reset All		Yes, No

– Color Temp. Calibration

After replacing the lamp or in other cases where the

lighting changes, color temperature can be adjusted

using the color temperature sensor. For more information

on how to adjust color temperature, see “Color

Temperature Adjustment” (☞ P.26).

– Reset Lamp Life

If the lamp is replaced before reaching its 2000 hours

lamp life, be sure to reset the lamp’s life counter. To do

Color Temp. Calibration?

Yes		No

–Auto Power Off

When the auto power off feature is set to Enable, power to the projector automatically shuts off if no signals are received and no operations are performed for about 10 consecutive minutes. If 9 minutes pass without the projector receiving any signals or being operated in anyway, the below message appears on the screen.

Auto Power Off

It will be standby mode soon.

this, select “Reset Lamp Life” from the Configuration

menu. When the user selects this item, the following

message appears:

Select “Yes”, and press the ENTER button. Then the

lamp life is initialized.

– Reset All

All settings are reset to the factory default settings except

Reset Lamp Life ?

Yes		No

About 1 minute after the message appears on the screen, power to the projector shuts off.

Note:

After the above message appears on the screen, pressing any button on the projector or remote control other than the / I button on the projector and the ON or STANDBY buttons on the remote control resets the auto power off feature.

The auto power off feature will activate again if, after that, the projector goes without receiving any signals or being operated in anyway for 10 consecutive minutes.

–Tigger 2

Select either 12V output or 0V output by choosing On or Off for each aspect mode. Full, Normal, Zoom, and Through.

This allows you to control such as a powered dual aspect screen with the outputs for the aspect modes.

On: Output DC 12V.

Off: No output.

the lamp life.

When the user selects this item, the following message

appears:

Select “Yes”, and press the ENTER button.

Reset All ?

Yes		No