Rear and Terminals View |
| Bottom View |
|
|
|
IR sensor
Ventilation hole
Lamp cover
Lamp cover
securing screw
Ventilation
hole
1 |
2
11
3
4
10
5 
6
9 
8
7
Ventilation holes
2
1
Adjustable |
|
feet | 1 |
|
2Adjustable feet
ENGLISH
zAC IN (☞ P.8)
Connect the supplied AC power code.
xRGB IN
Connect the analog RGB output from an IBM VGA or compatible equipment.
cCOMPONENT VIDEO IN 1 and 2
Terminals 1 and 2 have each Y, PB/CB, PR/CR terminals. Connect them to the component video output of a video device, AV amp/processor, DVD player, etc.
v
Connect the
bVIDEO IN
Connect the composite video output from a video equipment.
nTRIG.1(TRIGGER 1)
When the unit is turned on, 12V is output. When the unit is turned off, no voltage is output. This allows such as a powered up/down screen,whenever the projector is turned on or off.
Note:
To connect with external devices, use an ordinal 3.5mm
mREMOTE IN/OUT
By connecting this projector to another Marantz audio component using a supplied System Control cable, you can remotely operate the components as a single system.
•When connecting to component with a remote sensor (such as the SR9500,SR8500), be sure to connect the "REMOTE CONTROL IN" jack of this projector to the "REMOTE CONTROL OUT" jack of the component with the remote sensor.
Note:
For connections, always use the included bus control adaptor cable.
,TRIG.2(TRIGGER 2)
Select ON or OFF at each aspect mode, such as Full, Normal, Zoom, and Through to control screen aspect ratio with powered up/down dual aspect ratio screen.
Notes:
•Do not use TRIG.1 and TRIG.2, as the power source.
•To connect with external devices, use an ordinal 3.5mm
.HDMI IN 1 and 2
Connect the digital RGB signal (TMDS compliant, single link only)
Note:
To use the HDMI terminal, please follow the cautions on page 9.
⁄0LIGHT ON/OFF
Select ON : The terminal panel lights up.
This is the control port for the custom installer.
zAdjustment lever (☞ P.11)
Lift the projector and turn the adjustment lever right or left. The adjustable feet will extend from the projector. Then, release the lever, the adjustable feet is locked.
xScrew holes for ceiling mount kit
5