JVC TM-H150CG manual Controls and Features cont’d, Rear Panel

Controls and Features (cont’d)

Rear Panel

e
	SLOT
	i
	REMOTE
r	o
	MAKE/
	TRIGGER
t	;

POWER

y

u a

eVIDEO A terminal

Input (IN) and output (OUT) terminals for composite signals.

uAUDIO B terminal

Input (IN) and output (OUT) terminals for analog audio signals.

• The IN and OUT terminals are bridge-connected (auto	• The IN and OUT terminals are bridge-connected (auto
termination).	termination).

NOTE:

Use the AUDIO A terminals for the corresponding audio signals.

NOTE:

Use the VIDEO B terminals for the corresponding video signals.

rVIDEO B terminal

Input (IN) and output (OUT) terminals for composite signals.

•The IN and OUT terminals are bridge-connected (auto termination).

NOTE:

Use the AUDIO B terminals for the corresponding audio signals.

tVIDEO B (Y/C IN,Y/C OUT) terminal

Input (IN) and output (OUT) terminals for Y/C (S- video) signals.

•The Y/C IN and Y/C OUT terminals are bridge-connected (auto termination).

NOTES:

•Use the AUDIO B terminals for the corresponding audio signals.

•When both an Y/C (S-video) signal and a composite signal are input to the VIDEO B terminal, the Y/C signal has priority over the composite signal.

yAUDIO A terminal

Input (IN) and output (OUT) terminals for analog audio signals.

•The IN and OUT terminals are bridge-connected (auto termination).

NOTE:

Use the VIDEO A terminals for the corresponding video signals.

iInput card slot

When using the input card (not supplied), install the card to this slot.

oREMOTE (external control) terminal Terminals for controlling the monitor by an external control.

\ For details, see page 15.

;Main power switch

Turns on and off the main power.

• I: ON ‡: OFF

NOTE:

When turning on the main power, the power lamp lights up as follows:

•Orange: The monitor is in stand-by mode.

•Green: The monitor is on.

aAC inlet

Connect the supplied AC power cord to this inlet and an AC outlet (120 V AC/220 – 240 V AC, 50 Hz/ 60 Hz).

6