Menu Configuration (cont.)
SIZE/POSI. ADJ.
Adjusts the size and position of the picture.
Item | To do | Setting value |
H SIZE*1 | Adjust the horizontal picture size. | Setting value varies depending on |
H POSITION*1 | Adjust the horizontal picture position. | the signals. |
V SIZE*1 | Adjust the vertical picture size. |
|
V POSITION*1 | Adjust the vertical picture position. |
|
sub menu | Display the sub menu which enables you to adjust the items of “SIZE/POSI. ADJ.” while viewing the actual picture. | |
reset | Restore the default settings for all the items in “SIZE/POSI. ADJ.” |
|
*1 Memorized for each signal format.
WHITE BALANCE SET.
Selects the GAMMA correction value, color temperature and adjusts the drive level and cutoff point of each color (R/G/B).
Item | To do | Setting value | |
COLOR TEMP. | Select the color temperature. | 9300K, 6500K, USER | |
R DRIVE | Adjust the drive level of each color (red, green, and blue). | MIN – 000 – MAX (in 256 grades) | |
G DRIVE |
|
|
|
B DRIVE*2 |
|
|
|
R CUT OFF | Adjust the cutoff point of each color (red, green, and blue). | MIN – 000 – MAX (in 256 grades) | |
G CUT OFF |
|
|
|
B CUT OFF*2 |
|
|
|
sub menu | Display the sub menu which enables you to adjust the items in “WHITE BALANCE SET.” while viewing the actual | ||
| picture. |
| |
reset | Restore the default settings for the drive levels and cutoff points of the selected color temperature. | ||
*2 Memorized for each color temperature. |
| ||
|
| ||
REMOTE SETTING | (☞ “External Control” on pages 18 to 21) |
| |
Settings for the external control |
| ||
Item | To do | Setting value | |
SERIAL TYPE | Select the input terminal used for external control by serial communication. | RS232C, RS485 | |
PARALLEL TYPE | Select the external control method for the MAKE/TRIGGER terminal. | MAKE, TRIGGER, SET | |
PIN1 | Assign the control functions to the pins of the MAKE/TRIGGER terminal. | ☞ “Functions controlled by the | |
PIN2 | • Assign a function to each pin terminal by selecting “SET” in “PARALLEL | MAKE/TRIGGER system” on page | |
PIN3 |
| TYPE” mentioned above. | 19 |
PIN4 |
|
|
|
PIN5 |
|
|
|
PIN6 | The functions are assigned for “PIN6” – “PIN8” and you cannot change the | ☞ “Using the MAKE/TRIGGER | |
PIN7 | assignment of these functions. | system” on page 18 | |
PIN8 |
|
|
|
16