JVC DT-R24L4D, DT-R17L4D user service „ Self-check program, Check which lamps are flashing

Page 23

„Self-check program

This monitor has a self-check function, which allows it to detect malfunctions and alert you. This makes troubleshooting easier. Whenever a problem occurs, one or some of the INPUT SELECT lamps will flash. If this happens, follow the steps below and contact your dealer to resolve the problem.

The illustration of the monitor is of DT-R24L4D.

When the screen goes blank, and one or some of the INPUT SELECT lamps (For DT-R24L4D: DVI, VIDEO1, VIDEO2 / For DT-R17L4D:

SDI 2, DVI, VIDEO) on the front control panel start flashing...

1

Check which lamps are flashing.

2

Press

 

 

 

button to turn off (on standby) the monitor.

 

 

 

 

 

 

3

Turn off the power switch on the rear panel.

4

Disconnect the AC power cord from the AC outlet.

5

Contact your dealer with the information about which lamps were flashing.

•If you turn on the monitor soon after turning it off (or after a short-term power failure), the INPUT SELECT lamps may flash and no image may be displayed.

When this happens, turn off power and wait at least 10 seconds before turning on the monitor again. If the INPUT SELECT lamps do not flash, you can use the monitor as normal.

EN

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents DT-R24L4D DT-R17L4D Table of Contents How to replace the fuse Safety PrecautionsPower Connection A. only To prevent an accidental fallImportant Recycling Information Fixing the monitor„ Caution for use of the product for many hours „ Caution for use of the product in the high temperature„ Maintenance To detach the stand InstallationTo install the stand To install the monitor on a wall DT-R17L4D Connections„ Rear panel DT-R24L4DDVI-D Hdcp terminal Attaching the power cord holderDT-R17L4D DT-R24L4D Daily Operations„ Front panel Press Menu button Press or button when a menu is not displayedDisplay the menu „ The operation procedure„ Menu Transition Diagram Menu ConfigurationMARKER*1*2 Picture FunctionBack Light Auto AspectAudio Setting Picture SUB ADJ Function SettingSync Function White Balance SET Remote SettingSIZE/POSI. ADJ Control Lock Setting of Character SETAll reset Information„ About the external control „ Using the MAKE/TRIGGER systemExternal Control DT-R24L4D Video Tally SELSDI DVI„ Using the serial communication Basic command list Commands Functions Data Troubleshooting Check which lamps are flashing „ Self-check program„ Input/output terminals Specifications„ General „ LCD panelDT-R17L4D DT-R24L4DINPUT1, INPUT2 „ Available signalsVideo signals Video Audio HD/SD SDID.S Clock+ Computer signals preset DVI-D Hdcp terminalsSpecification of the DVI-D Hdcp terminal GND
Top Page Image Contents