ENGLISH 
Adjustments and settings in the menu (continued)
|
|
|
| Lamp Power | It is possible to change the brightness of the lamp. |
|
(*)If continually used with "High", the lamp will become dark earlier.
(*)The more one lets the interior temperature of the device rise due to generation of heat, the less the level of tolerance against high temperatures.
(*)For about 60 seconds after the lamp is lit, the lamp cannot be switched off.
|
|
| Settings: Normal, High | [Normal] |
|
|
| ||
|
| Normal | Normally this setting is chosen.(160W drive) |
|
|
| High | In a bright room, when the video is hard to see, this setting is chosen.(220W drive) | |
|
| |||
[1-2-1] Sharpness
Sharpness | Emphasizes the outlines of video images. Please adjust to your preference. | |
| Values: 0 to 50 | (clear) |
Detail Enhance | It makes minute details of the video images stand out. Please adjust to your preference. | |
| Values: 0 to 50 | (strong) |
[1-2-2] Custom Gamma
Custom 1~3 | [1] It is possible to select a gamma curve adjustment for Custom 1, 2, and 3 under the |
| "Gamma" of the picture adjust and then save it. |
| Please adjust to your preference. |
(*)Initial values of Custom 1, 2, and 3 are the same as for "Normal".
(*)Please refer to the figure at the bottom of the menu in two frames for adjustment.
(*)It is recommended that you read "Gamma Curve" (page reference: 56) for hints about adjustment.
Correction Value | You can choose to add the underlying gamma curve adjustment. |
(*)Can choose any setting, as the default gamma curve will always appear linear. Settings: Normal, A, B, C, D
(brightens in particular dark to intermediate parts) 1.8 to 2.6 (darkens in particular dark to
|
|
| intermediate parts) in the range of values with increments of 0.1 | [Normal] |
| Gamma Adjustment | The gamma curve for "green" is being displayed as being representative. If "white", "red," | ||
|
|
| "green" or "blue" are selected, the corresponding color curves are displayed. |
|
|
|
| Place the cursor on a gamma curve with 12 points with the buttons for left and right, and | |
|
|
| then use the buttons for up and down buttons to move those points up or down. |
|
|
|
|
| |
|
| White | Red, green and blue can be adjusted at the same time. |
|
|
| Red | It is possible to adjust the gamma curve of red. |
|
|
| Green | It is possible to adjust the gamma curve for green. |
|
|
| Blue | It is possible to adjust the gamma curve for blue. |
|
|
|
| ||
| Reset | The same data as for the "Normal" mode are used. |
| |
(*)When you exit the adjustment menu of Custom Gamma, please save the adjustment values.
You can return to the original data, which should be saved.
(*) |
|
|
|
|
Picture Adjust |
|
|
|
|
>> Custom Gamma |
|
| ||
Custom1 | Correction Value | Normal | ||
Custom2 |
| White | 1023 |
|
| Red |
|
| |
Custom3 |
|
|
| |
| Green |
|
| |
|
|
| Gamma curve | |
|
| Blue | 512 |
|
|
|
|
| |
Gradation at the | Reset | 0 | Gradation diagram corresponding | |
| to the gamma curve. | |||
selected point. |
|
|
| |
Exit |
| Operate Back | ||
MENU Select |
|
| BACK | |
Operation
49