Knoll Systems LED1081 user manual PIP Split Mode

•Top Left: This places the PIP source into a 644x362 designated image area at the top left of the screen.

•Top Right: This places the PIP source into a 644x362 designated image area at the top right of the screen.

•Bottom Left: This places the PIP source into a 644x362 designated image area at the bottom left of the screen- safe area of the DMD.

•Bottom Right: This places the PIP source into a 644x362 designated image area at the bottom right of the screen-safe area of the DMD.

•PBP (Picture-By-Picture): This reduces the designated image area of the Active source to 921x518 and places it next to the PIP source, which is also in a 921x518 image area. These two images are centered on the screen.

•Split: This is the mode in which the active source is also used as the PIP source and placed in a PIP area equal to half the display on the left side. This results in the right half of the image being the active source and the left half is the PIP source.

Figure 4-6: PIP Split Mode

•Memory: Select to save user defined settings.

The following items are saved (for all sources, not just the active source):

•Brightness / Contrast

•Sharpness (all settings in sub-menu)

•HSG (all settings in sub-menu)

•Color Temperature

•Color Gamut

•Dynamic Iris

•RGB Adjust (all settings in sub-menu)

•Color Saturation / Color Tint

•Noise Reduction (all settings in sub-menu)

•Color Space

•DLP Frame Rate

•BrilliantColor

•Adaptive Contrast

38Operation