Knoll Systems LED1081 user manual Memory Sub-Menu

•Recall Memory: Select Memory from the General menu, and then press Enter to activate Recall Memory.

Use the or buttons to select the modes: User-1, User-2 or Default.

•Save Settings: Select Memory from the General menu, and then press to highlight Save Settings.

Use the or buttons to select the modes: User-1 or User-2.

Figure 4-7: Memory Sub-Menu

•Blank Screen: Select Blank Screen from the GENERAL menu to choose the color of the blank screen that appears when no source signal is present. The options are Logo, Black, Blue and White. The default is Black.

•Logo Display: Select to enable or disable the splash screen.

•Auto Source: This function scans for active sources when the current source is not available (default setting is Off).

•Test Patterns: The LED1081 has numerous internal test patterns that are useful to technicians for advanced cali- bration, measurement and fault isolation purposes. To access them, select Test Patterns from the GENERAL menu and set it to On. The available test patterns are:

•White

•Black

•Red

•Green

•Blue

•Cyan

•Magenta

•Yellow

•ANSI Checkerboard

•Horizontal Gray Ramp

•Focus Grid

Press or on the remote control unit or built-in keypad to cycle through the test patterns.

Note The OSD menus are not available when in “test pattern” mode.

To turn test patterns off, press any key other than or on the remote control unit or built-in keypad.

•Blue Only: This feature removes all red and green color information from the image, and is useful for color-calibrat- ing the projector or other video components.

operaTion