Knoll Systems LED1081 user manual Trigger commands are deactivated when a PIP source is active

•HDMI 1/HDMI 2: Enables or disables the HDMI 1 and HDMI 2 sources.

•RGB: Enables or disables the RGB source.

•Comp 1/Comp 2: Enables or disables the Component 1 and Component 2 sources.

•Video: Enables or disables the Composite video source.

Note If either Component 1 or Video is enabled, SCART must be disabled.

•S-Video: Enables or disables the S-Video source.

•SCART: Enables or disables the SCART RGBS source.

Note If SCART is enabled, both Component 1 and Video must be disabled.

•Auto Power Off: Set Auto Power Off to On to have theLED1081 turn itself off after 20 minutes of inactivity (no source signal present).

•Auto Power On: Set Auto Power On to On causes the projector to automatically power up when AC power is present. If the projector is plugged into a switched AC outlet, this allows the projector to be turned on using a wall switch instead of the remote control unit. If you do not need this capability, set Auto Power On to Off (this is the de- fault setting).

•Rear Projection: This control reverses all images and menus, and is necessary when the projector is used in rear- projection applications. The default is Off.

•Ceiling Mode: This control flips the image so the projector can be used in ceiling mounted installations.

•Trigger-1:Select the primary screen trigger condition:

•LED: Triggers the screen when the LED is turned on.

•16:9, Letterbox, 4:3, or 4:3 Narrow: Triggers the screen when the selected aspect ratio is active.

•RS232: Triggers the screen when the RS232 “Trigger On” command is received.

•Trigger-2:Select the secondary screen trigger condition (see descriptions for Trigger 1).

Note Trigger commands are deactivated when a PIP source is active.

•Factory Reset: Select Factory Reset to restore all projector settings - except those listed below - to their factory-default values:

•LED Hours

•Model Name / Serial Number

•Language

•User Memory 1 / User Memory 2

Operation 53