Elmo HV-5000XG RS-232C Specifications, Cable connection, RS-232C connector specifications Dsub 9P

6. RS-232C SPECIFICATIONS

The Presenter can be controlled by a PC connected to the Presenter through the RS-232C terminal [RS-232C].

Setting up

(1)Connect the Presenter to a PC with an RS-232C connection cable.

Notes: - When using an RS-232C cable available in the market, make sure of the connection shown in the page.

-To protect the Presenter and the PC, be sure to turn OFF all the power switches of all equipment before connecting.

(2)Start up the PC, and set the RS-232C baud rate (transmission rate) to 9600bps.

Note: For the information how to set the communication mode of the RS-232C, refer to the instruction manual of

the PC.

(3)Send the command to operate the Presenter from the PC (Refer to the list of communication commands).

(4)Control through the RS-232C will start.

Note: For communication control, be sure to take the above steps for setting.

Cable connection

				Visual Presenter side
				(DSUB 9P)
DSUB 9P (Female)					1
				CD
5	4	3	2 1	RXD	2
				TXD	3
				DTR	4
				SG	5
				DSR	6
9	8	7	6	RTS	7
				CTS	8
				RI (CI)	9

DOS/V side (DSUB 9P)

1	CD	DOS/V side : DSUB 9P (Female)
2	RXD	5	4	3	2 1
3	TXD
4	DTR
5	SG
6	DSR
7	RTS	9	8	7	6

8CTS

9RI

RS-232C connector specifications (DSUB 9P)

Pin No.	Code	Name	Direction of data			Comments
			Visual Presenter	PC
1	CD	Carrier Detect			CD	: Carrier Detect
2	RXD	Received Data			RXD : Received Data
3	TXD	Transmitted Data			TXD : Transmitted Data
4	DTR	Data Terminal Ready			DTR	: Data Terminal Ready
5	SG	Signal Ground			SG	: Signal Ground
6	DSR	Data Set Ready			DSR	: Data Set Ready
7	RTS	Request To Send			RTS	: Request To Send
8	CTS	Clear To Send			CTS	: Clear To Send

25