TANDBERG D12817-05 user manual Getting started, System start-up, Welcome menu

Page 17

TANDBERG Videoconferencing System	Getting started

Getting started

System start-up

Your system should be in standby mode. When in standby mode, pressing any key or picking up the remote control will wake up the system. An incoming call will also wake up the system.

If the system does not respond, make sure the system is switched on by using the On/Off switch located at the rear of the Codec. After a few seconds you should see the ‘Welcome’ menu on the monitor.

If this does not help, verify that your monitor is switched on. To switch the monitor on you normally push the power button on the front of the monitor (depending on monitor type).

Welcome menu

After the system has performed a self-test routine, product logo and a ‘Welcome’ menu will be displayed on the monitor. This menu should provide you with the most important system information. The three color-coded commands shown correspond with the Quick keys on the remote control. This means that to make a call, you can press the green quick-key.

17

Image 17

Contents Page Tandberg Videoconferencing System Trademarks and copyright Environmental IssuesOperator Safety Summary Contents Appendices Index Advanced usePeripheral Equipment TIP IntroductionLAN Menu structureAt a glance the Tandberg 550 system Tandberg 550 Videoconferencing SystemCamera Remote controlCodec Table microphoneUnpacking InstallationPrecautions Monitor cables Connecting cablesMicrophone cable 5b. Wireless LAN Insert PC Card Power cableIsdn cables 5a. LAN cableSelect Audio/Video input on monitor Power onMenu System configurationLAN configuration Isdn configurationWelcome menu Getting startedSystem start-up Basics Making a call Making and ending callsTIP Selecting / setting default quality bandwidth Selecting / setting default network Correcting keying mistakes Answer a callEnd a call Directory Delete Entry Add New EntryEdit Entry Do Not Disturb / Sleep Mode Adjusting volumeGeneral use View outgoing video selfviewOn Screen Symbols Controlling the Main Camera Focusing cameraSelecting video sources Moving / zooming cameraVoice Activated Camera Positioning Storing presets PresetsSelecting presets Far end camera control Fecc Sending a snapshot Sending and receiving snapshotsViewing a snapshot Receiving a snapshotExternal MCU control functions Quick Menu Page Text Chat / Closed Captioning Web-interfaceOther PC applications PC SoftPresenterStreaming SnapshotsMain menu Menu PasswordAdvanced use Call quality VGA ResolutionsAudio VideoFar end camera control UtilitiesAutoanswer MCU status line Welcome MenuSystem Name Camera BrightnessAuto Request Floor Web SnapshotsISDN-BRI Settings Terminal SettingsSpids This Service has Limited Access on Some Isdn Networks Parallel dial LAN Settings Page Settings Page Rsvp Advanced H.323 SettingsQoS Type IP Type of Service TOSIP Precedence DiffservIP Settings Page Wireless LAN Settings Increased Encryption Level will Decrease Performance Snmp Settings Video Call Alert Tone / Alert Volume Audio SettingsAudioIn Mode Echo Control Key TonesVGA Settings VNC Settings Access Code Call SettingsIncoming telephone calls Fallback to telephonyEncryption Secure Conference Encryption ModeNetwork Profiles Max Call LengthPage Dataport configuration Software Options LanguageChannel status DiagnosticsSystem info TIP IP Address Conflict Check Restore defaultsCall status Test subsystem View current settingsInterfaces Peripheral EquipmentPage Tracker Document cameraAppendix 1 Security AppendicesAppendices Tandberg Videoconferencing System Optional feature Appendix 2 Using the file system Custom logos · Go to the folder where your logo is located Appendix 3 Declaration of Conformity Index Index Tandberg Videoconferencing System