Texas Instruments bq24010/2 Schematic, Physical Layouts, and Bill of Materials, Chapter, Page

Page 14

Schematic, Physical Layouts, and Bill of Materials

Chapter 3

Schematic, Physical Layouts, and Bill of Materials

This chapter contains the schematic diagram, the board layouts and assembly drawings, and the bill of materials required for the EVM.

Topic		Page

3.1	Schematic	. . 3-2
3.2	Physical Layouts	. . 3-3
3.3	Bill of Materials	. . 3-5
3.4	Reference	. . 3-5

Schematic, Physical Layouts, and Bill of Materials

3-1

Image 14

Contents User’s Guide SLUU125APMP Portable Power JanuaryIMPORTANT NOTICE EVM IMPORTANT NOTICE EVM WARNINGS AND RESTRICTIONS Figures Contents3 Schematic, Physical Layouts, and Bill of Materials TablesContents Page IntroductionChapter Topic1.1 Background 1.2 Performance Specification SummaryTable 1-1. Performance Specification Summary Test Summary Test Summary2.2 Test Procedure 2.1 I/O and Jumper ConnectionsIn place of a battery, a source meter that can sink current can easily be adjusted to test each mode 2.2.1 Equipment 2.2.2 Equipment Setup2.2.3 Procedure Figure 2-1. Load Test Board4 Verify that output voltage BAT+ settles between 3.2 V and 3.95 Schematic, Physical Layouts, and Bill of Materials Schematic, Physical Layouts, and Bill of MaterialsSchematic Physical Layouts3.1 Schematic 1 µ F3.2.1 Board Layout Figure 3-2. Assembly View3.2 Physical Layouts Physical LayoutsFigure 3-3. Top Layer Figure 3-4. Bottom Layer Table 3-1. Bill of Materials 3.3 Bill of Materials3.4 Reference Bill of Materials