Onkyo TX-SR574 First Time Setup, Minimum Speaker Impedance Setup not North American model

First Time Setup—Continued

ON/STANDBY

REMOTE MODE

			RECEIVER	DVD
			TAPE
	INPUT SELECTOR			M D/CDR
	1	2	3	CD
				HDD
	V1	V2	V3
	4	5	6	T V
	MULTI CH		DVD
	7	8	9	VCR
	TAPE	TUNER	CD	CABLE
	10	11	12
	+10	0	CLR	SAT
	D TUN	ENT
	--/---	DIMMER	SLEEP
	TV	VOL	CH	VOL
			DISC
			ALBUM
	INPUT
	GUIDE			PREVIOUS
	TOP MENU			MENU
	SP A / B			MUTING
2–8		ENTER
	PLAYLIST/CAT		PLAYLIST/CAT

RETURN

RETURN			SETUP
	LISTENING MODE
STEREO	SURROUND
AUDIO	SUBTITLE RANDOM		REPEAT
TEST TONE	CH SEL	LEVEL-	LEVEL+

1

1, 9

3	Use the Left and Right [ ]/[ ]
	buttons to select the setting for

“Impedance.”

4 ohms: Select if the impedance of any connected speaker is 4 ohms or more but less than 6.

6 ohms: Select if the impedances of all connected speakers are between 6 and 16 ohms.

Press the [RETURN] button to go to step 2 of the “Speaker Configuration” (see page 35).

Note:

•This procedure can also be performed on the AV receiver by using the [SETUP], [ENTER], and arrow buttons.

Minimum Speaker Impedance Setup (not North American model)

If the impedance of any of the connected speakers is 4 ohms or more but less than 6, set the minimum speaker impedance to “4 ohms.”

Note:

Before you change this setting, turn down the volume.

1 RECEIVER Press the [RECEIVER] button,

followed by the [SETUP] button.

	SETUP
2	Use the Up and Down [ ]/[ ]
	buttons to select “0. Hardware

Setup,” and then press [ENTER].

Component Video Setup

If you connect a video component to COMPONENT VIDEO IN 1, 2, or 3, you must assign that input to an input selector. For example, if you connect your DVD player to COMPONENT VIDEO IN 2, you must assign COMPONENT VIDEO IN 2 to the DVD input selector. To upconvert and output composite video and S-Video sources from the COMPONENT VIDEO OUT, select the VIDEO setting.

Here are the default assignments.

Input selector	Default assignment
DVD	IN1
VIDEO 1	VIDEO
VIDEO 2	VIDEO
VIDEO 3	VIDEO

1 RECEIVER Press the [RECEIVER] button,

followed by the [SETUP] button.

	SETUP
2	Use the Up and Down [ ]/[ ]
	buttons to select “1. Compo-

nent,” and then press [ENTER].

34