Manual Adjustment of Personal Computer Images
Menu Operation
Adjusting Clock Frequency and Phase
1 Select RGB as the input (page 20).
2 Press the MENU button to display the main menu and then press the cursor / keys to select the “IMAGE”.
3 Press the cursor / keys to select the “CLOCK”.
4 Press the cursor / keys and adjust the
image width in relation to the screen.
Adjustment is performed in dot units. Adjust to the position where vertical flicker disappears.
5 Press the cursor / keys and select “PHASE”.
6 Press the cursor / keys and adjust to minimize image noise, flicker, color variations, etc.
Reconnecting a separate personal computer or other device to the COMPUTER input terminal
Either press the AUTO SYNC button on the main unit or open the FLIP COVER of the remote control and press the AUTO SYNC button there.
If no images appear during setting
Use the following procedure when no images appear during setting because the clock frequency or phase is grossly inaccurate.
1Turn off the power of all devices connected.
The input signal will stop and either a blue or black background (This depends on the “BACKGROUND” setting on page 32) will be projected.
2Perform a reset (page 29).
3Readjust the “CLOCK” and “PHASE”
Adjusting the position of the image
If the image is offset up, down, left or right, adjust the vertical and horizontal position.
1 Perform steps 1 - 6 for “Adjusting the Clock Frequency and Phase” on this page.
2 Press the cursor / keys and select “POSITION”.
3 Press the cursor / , / keys and adjust the horizontal and vertical position.
To close the menu
Press the
28