Technicolor - Thomson 605S manual Napt Manager on

3 SpeedTouch™ Web Interface

NAPT Clicking this button displays the Network Address and Port Translation (NAPT) page. This page allows you to:

•View or add/delete specific static NAPT entries:

To add static NAPT entries proceed as follows:

1Click New.

2Specify the outside address and inside address for the entry as well as the protocol and port to which the entry applies.

Note	If the NAPT entry is applied to a connection's dynamically assigned
	local peer IP address, you should specify 0.0.0.0 as the outside address.

3Click Apply to add the entry to the table.

You can also add static NAPT entries semi-automatically using the SpeedTouch™

NAPT Manager. For more information on NAPT Manager, see “4 SpeedTouch™

NAPT Manager” on page 51.

•View or add/delete Multi-NAT entries:

To add Multi-NAT entries proceed as follows:

1Click New.

2Specify the inside address and put the desired range between brackets e.g. 10.0.0.[1-10]. Specify the outside address and interface.

3Click Apply.

42 E-SIT-CTC-20030605-0003 v1.0