Seiko Group FB300 manual Do not use pencils

Page 27

5.To change the values of the serial interface parameters, fill in the marker ( ) beside the value you want to set with a black or blue ball-point pen or a fiber-pen.

Do not use pencils.

W ORD LENG TH	( )	( )
	disabled *	enabled
BA UD RATE	( )	( )
	disabled *	enabled
PA RITY B IT	( )	( )	( )
	DTR	X O N/XO FF* X ON /X O F F + DT R

If more than one value is set for a parameter, the printer ignores these parameters and maintains

the currently set value.

Do not fill in the marker beside the title of the preprinted form, otherwise the printer will not be

able to read that page.

6.Once the serial interface parameters have been signed, insert the sheet back into the printer.

7.The printer reads the selected values on the configuration sheet and sets them. The settings are confirmed by a # symbol printed on the left of the corresponding marker.

The printer then returns to normal functioning mode.

For a complete description of the printer setup procedure see the paragraph “Printer Setup” later

in this manual.

25

Image 27

Contents FB300 Table of Contents Printer Presentation Automatic paper thickness adjustmentAutomatic switching between cut sheets and fanfold paper Notify any damage to your supplier Unpacking the PrinterFront view Printer PartsRear View Choosing a Suitable Location Printer InstallationInstalling the Paper Stand Page Installing the Power Cable Installing the Ribbon Cartridge Page Loading Paper Paper HandlingLeft Limit Page Loading fanfold paper Page Make sure, that the paper is inserted correctly straight Function keys Operator PanelKey pressed Display Offset AdjustmentLeds Printer SetupSoftware Driver Selection Serial Connection to the HostParallel Interface Setting the Interface ParametersDo not use pencils Printing a Test Configuration SetupProgram Setup Printing the Printer Setup Forms Printer SetupIf you press the on Line key If you press the LQ key Reading the Preprinted Forms Filling in the Printer Setup FormsPrinter Setup Flow Chart Setup Parameters Input Buffer Autofeed SignalSLCT-IN Signal Interface TypeGET Edge Quote Security ModeTear Adjust Auto GAP OffsetVertical Pitch ProtocolFont Horizontal PitchRight Margin Left MarginBottom Margin TOP MarginNation C-SET USA, FRANCE, GERMANY, England IBM C-SETIBM Compress Epson C-SETLF=LF+CR Line Mode LF=LF, CR=CRWrap Mode CR=LF+CRTear Mode Park ModeManual Loading Offset AdjustmentsAlign Mode GAP ModeOffset Tuning Setup X X Clearing Paper Jams TroubleshootingPage Page Problem Cause Solution Print Quality ProblemsHexadecimal Dump Use paper matching the indicated characteristics Paper SpecificationsInt a r ea Cut SheetsPrint Area Fanfold PaperCharacter Set Technical SpecificationsInterfaces Power Supply FCC Notes Canadian D.O.C. Radio Interference RegulationEEC Regulations