Setup Parameters
The following is a listing of the setup parameters.
Configuration Sheet
Setup Parameter | Values | Description |
|
|
|
RESTORE TO MFG | no | The selected values are not set to factory defaults. |
| all | The values set in all printer setups are reset to factory default |
|
| values. |
| config | The values set in the configuration setup are reset to factory default |
|
| values. |
| prog.1, prog. 2, | The values set in the corresponding program setup are reset to the |
| prog.3, prog 4 | factory default values. |
|
|
|
DISPLAY LANG. | English, Italian, | Defines the language of the display messages. |
| German, French, |
|
| Spanish |
|
|
|
|
PROGRAM | progr.1, progr.2, | Defines the default Program Setup or Setup couple. The program |
| progr.3, progr.4, | couples may be selected only if the same emulation has been |
| progr.1/3, progr.2/4 | selected for the two setups. |
|
|
|
PROGRAM LOCKED | no, yes | Locks the program setup selection. In case the lock is ‘enabled’ the |
|
| program setup cannot be changed pressing the PROGRAM key. |
|
|
|
ERROR BUZZER | 1 beep, no beep | Selects the behavior of the buzzer in case of an error. |
|
|
|
JOB BUZZER | no beep, 1 beep, | Selects the behavior of the buzzer when a new print job begins: no |
| continuous | signal (no beep), one beep (1 beep) or a continuous beep |
|
| (continuous). |
|
|
|
33