Network Scanner Tool Setup

After installation, the Network Scanner Tool setup wizard automatically starts and scans your network to detect Sharp multifunction copiers. The configuration utility provides default destination identification and image processing commands, which may be further modified or expanded. Once specified, these definitions are stored in your copier’s Desktop Destination Profile web page (refer to the following table).

SETTING	DESCRIPTION
Profile Name	A name that appears on the copier front panel that refers to the rest of the
	settings in the destination profile. You typically select a profile by name
	before scanning a document.

IP Address or	This IP address or desktop host name is used to identify your computer
Desktop Host Name	that’s running the Network Scanner Tool.

Desktop Port	This number is used to contact the Network Scanner Tool on your
Number	computer. The default is 21. If you change this number in the web page, be
	sure to also make the change in each computer’s Network Scanner Tool
	configuration that will receive scans from the copier.

Process Directory	The Process Directory setting specifies the name of the currently selected
	Process Definition. Process Definitions that are defined in the Network
	Scanner Tool. For example, “Convert by OCR” tells the Network Scanner
	Tool to execute the “Convert by OCR” process when a scanned image
	arrives. . See the Process Definition Tab discussion below for more
	information.

4	Network Scanner Tool User’s Guide