Sharp R2.7 manual System Requirements

Page 7

System Requirements

To successfully use the Network Scanner Tool, your computer must meet the following minimum requirements:

An Intel processor-based PC, Pentium 133 MHz or greater (Pentium MMX 200 MHz or better recommended)

Microsoft Windows 95

Microsoft Windows 98

Microsoft Windows Millennium

Microsoft Windows NT® 4.0 Workstation with Service Pack 4 or later

Microsoft Windows 2000 Professional

Microsoft Windows XP Professional / Home Edition

Internet Explorer 5.0 or later. Sharpdesk will install a minimal version of Internet Explorer 5.01 if this requirement is not available on your system.

At least 32 megabytes (MB) of RAM. (64 MB or more recommended. Performance is enhanced with additional memory)

At least 110 MB of available hard disk space (including Sharpdesk)

SVGA monitor, 800 x 600 resolution, 256 colors (True Color recommended)

An Internet connection to access Sharp Internet product support sites.

Installed TCP/IP network

Installed Network Interface Card

Network Scanner Tool User’s Guide

3

Image 7
Contents Network Scanner Tool R2.7 Trademark Acknowledgements CopyrightTable of Contents File Naming Introduction Chapter OverviewOrganization About This GuideTerm Definitions System Requirements Network Scanner Tool Setup Chapter Preparing the Network Set up Copier Network Parameters Set up the Dhcp and DNS serversDetermine the Network Policy Notify the network users TroubleshootingTechnical Information Network Scanner Tool User’s Guide Chapter Installing the Network Scanner Tool Network Scanner Tool Installation Chapter Using the Network Scanner Tool About ConfigureNetwork Scanner Tool Menu System Tray Icon Start/Stop/ExitProcess Definition Tab Configuring the Network Scanner ToolCreating a New Process Definition Name Process Definition Properties OptionsLaunch Program Move File to Folder Deleting a Process Definition Process Definition DefaultCopiers Tab Examining Process DefinitionsCopiers New Button Options Adding a New CopierDeleting a Copier Examining/Changing Copier PropertiesAuto Detect Enable/Disable a CopierWeb Setup Cancel ChangesFile Naming System Options Tab
Related manuals
Manual 67 pages 5.05 Kb