Item | Explanation |
|
|
Pitch | Values: 10, 12, 17.14, 20 |
|
You can determine the font size by setting the number of characters that will print in one horizontal inch of type.
LPI | Values: 6, 8 |
|
You can set the number of lines printed in one vertical inch.
Auto | Values: Off, On | |
Wrap | ||
|
This item determines whether or not the printer automatically performs line feed when the data overflows the printable area of the print meterials.
Network menu
This menu lets you configure the network interface installed in your printer. You can reset the network interface and print a configuration page. For details, see page 4.1.
Item | Explanation |
|
|
TCP/IP | Values: DHCP, BOOTP, Static |
|
This item allows you to manually set the TCP/IP addresses or receive the addresses from the network.
•DHCP: The DHCP server allots the IP address to you automatically.
•BOOTP: The BOOTP server allots the IP address to you automatically.
•Static: You can enter IP Address, Subnet Mask, and Gateway manually.
EtherTalk | Values: Off, On |
| |
| This item lets you select whether or not you use the |
| EtherTalk protocol. Select On to use the protocol. |
NetWare | Values: Auto, 802.2, 802.3, Ethernet II, SNAP, Off |
| |
| This item lets you select the IPX frame type. |
•Auto: You can set the printer to select the frame type automatically.
•802.2: Select this value to use the IEEE 802.2 frame type.
•802.3: Select this value to use the IEEE 802.3 frame type.
•Ethernet II: Select this value to use the Ethernet 2 frame type.
•SNAP: Select this value to use the SNAP frame type.
•Off: You can disable the NetWare protocol.
Ethernet | Values: Auto, 10M Half, 10M Full, 100M Half, | |
Speed | ||
100M Full | ||
| ||
| This item allows you to select the ethernet speed. | |
|
| |
Clear | This item performs a simple reset and restores the | |
Setting | factory default settings for the network | |
| configuration. This setting will only take effect after | |
| you restart the printer. | |
|
| |
Network | This item prints a page showing the network | |
Info | parameters you set. |
2.7 <System setup>