Sharp AL-840 operation manual Using Other Installed Drivers

Page 23

STATUS MONITOR

Message

Solution

See

page:

 

 

Check Paper Tray : Out of Paper

The paper tray is out of paper or the paper did

Copier*5

or Misfeed

not feed correctly. Printing cannot continue

 

until you load the paper or clear the misfeed

 

 

 

 

in the paper tray.

 

 

 

 

Service Error

The product has detected a fatal error

–

Switch Main Power OFF on the

condition and cannot continue. Make a note

 

product. Wait approximately 5

of any specific error conditions or codes.

 

seconds. Switch Main Power

Then turn the product’s main power switch to

 

ON. If The Product Error

OFF. Wait for five seconds. Then turn the

 

continues, Contact your

product’s main power switch to ON. If the

 

authorized SHARP Service

product error condition persists, please

 

Center.

contact your authorized SHARP Service

 

 

Center.

 

 

 

 

Communication Error

The computer has lost communications with

–

The computer has lost

the product. Cancel the current operation.

 

communications with the

Then turn the product’s main power switch to

 

products. Cancel the current

OFF. Check the cable connections carefully.

 

operation, turn the product off,

Wait five seconds, Then turn the product’s

 

check the cable connection,

main power switch to ON. Try the print job

 

then back on, retry the

again. If the product communications error

 

operation.

condition persists, please refer to the

 

 

Operation manual.

 

 

 

 

*2: See the section on DRUM CARTRIDGE REPLACEMENT.

*3: See the section on INSTALLING THE TD CARTRIDGE.

*4: See the section on MISFEED REMOVAL.

*5: See the section on LOADING COPY PAPER.

USING OTHER INSTALLED DRIVERS

If you use another GDI printer or a Windows Printing System printer, interference between printers may occur and printing may not be performed properly.

To use another GDI printer or a Windows Printing System printer, you must change the port setting of the printer driver using the following procedure.

If another printer does not operate properly when the AL-800 series printer driver is set to “FILE”, uninstall the AL-800 series printer driver.

To uninstall the driver, see UNINSTALLING PRINTER DRIVER on page 23.

3

Printer trouble?

21

Page 22 Page 24
Image 23
Page 22 Page 24
Contents AL-840 Page Contents Trademark acknowledgments Getting StartedIntroduction Conventions used in this manualWindows Main FeaturesMaking floppy disks from CD-ROM Windows 95/Windows 98/Windows NTChecking the hardware and software requirements Installing the Printer Driver SoftwareInstalling the printer driver Description of the printer driverWindows 95/Windows NT To step Click the Next button Next button. Proceed to step Turn on the printer and then start Windows on your computer Readme DOS Emulation Help DOS Emulation SetupUninstall AL-800 Series AL-800 Series printer driver groupExecuting printing PrintingPrinting a On Line indicator Setting Print Conditions from Printer DriverIndicators on the operation panel Ready indicatorSetting Print Conditions from Printer Driver Image Quality Paper/OutputTricks About Print setting from the MS-DOS promptPrinting from AN MS-DOS Application DOS EmulationHP LaserJet Series II PCL4 Settings on the front panelSoftware printer setting ManagerPrinter TROUBLE? TroubleshootingPrinting problems Problem Possible cause Solution SeeMessage Description See the section on Connecting the Interface CableStatus Monitor Normal MessagesMessage Solution See Using Other Installed Drivers Select AL-800 Series, and then click the Connect button AL-800 Series , and Uninstall AL-800 Series Uninstalling Printer DriverAppendix SpecificationsParallel Interface ConnectorPin configuration 300 dpi Print Area600 dpi Index SpecificationsPage Sharp Corporation
Related manuals
Manual 31 pages 21.49 Kb
Top Page Image Contents