Sharp AL-840 operation manual Parallel Interface, Connector, Pin configuration

Page 27

PARALLEL INTERFACE

This printer uses a bi-directional parallel interface. Use the interface cable attached to the AL- 840.

●Use the parallel interface cable specified by SHARP for prevention of external

radio wave interference. For details, contact your SHARP service centre.

● For specifications of the parallel interface of your computer, see its operation manual.

Connector
36-pin DDK 57LE-40360-730B (D29)							18	1
female connector or equivalent connector							18	1
female connector or equivalent connector
Cable
Cable
Shielded type bi-directional parallel							36	19										4
interface																		4


For best results, use a printer interface
cable which is IEEE 1284 compliant.																		Appendix
The pin numbers and signal names are																		Appendix
Pin configuration
listed in the following table.

Pin No.			Signal name			Pin No.				Signal name

1						19		GND							RET)
1		STB				19		GND			(STB				RET)

2		DATA1				20		GND (DATA1 RET)

3		DATA2				21		GND (DATA2 RET)

4		DATA3				22		GND (DATA3 RET)

5		DATA4				23		GND (DATA4 RET)

6		DATA5				24		GND (DATA5 RET)

7		DATA6				25		GND (DATA6 RET)

8		DATA7				26		GND (DATA7 RET)

9		DATA8				27		GND (DATA8 RET)

10						28		GND								RET)
10		ACKNLG				28		GND				(ACKNLG				RET)

11		BUSY				29		GND (BUSY RET)

12		PE (Paper End)				30		GND (PE RET)

13		SLTC				31		INPRM

14						32
14		AUTO LF				32			FAULT

15		(NC)				33		(NC)

16		GND (0 V)				34		(NC)

17		FG				35		+5V


18		+5V				36		SLTC IN

25

Image 27

Contents AL-840 Page Contents Trademark acknowledgments Getting StartedIntroduction Conventions used in this manualWindows Main FeaturesMaking floppy disks from CD-ROM Windows 95/Windows 98/Windows NTChecking the hardware and software requirements Installing the Printer Driver SoftwareInstalling the printer driver Description of the printer driverWindows 95/Windows NT To step Click the Next button Next button. Proceed to step Turn on the printer and then start Windows on your computer Readme DOS Emulation Help DOS Emulation SetupUninstall AL-800 Series AL-800 Series printer driver groupPrinting Printing aExecuting printing On Line indicator Setting Print Conditions from Printer DriverIndicators on the operation panel Ready indicatorSetting Print Conditions from Printer Driver Image Quality Paper/OutputTricks About Print setting from the MS-DOS promptPrinting from AN MS-DOS Application DOS EmulationHP LaserJet Series II PCL4 Settings on the front panelSoftware printer setting ManagerPrinter TROUBLE? TroubleshootingPrinting problems Problem Possible cause Solution SeeMessage Description See the section on Connecting the Interface CableStatus Monitor Normal MessagesMessage Solution See Using Other Installed Drivers Select AL-800 Series, and then click the Connect button AL-800 Series , and Uninstall AL-800 Series Uninstalling Printer DriverAppendix SpecificationsConnector Pin configurationParallel Interface Print Area 600 dpi300 dpi Index SpecificationsPage Sharp Corporation

Related manuals

Manual 31 pages 21.49 Kb