Speaker system setup
POWER button
SENDING/ |
| SUBROOM | |
LEARNED |
| A B LEARN | |
POWER | SLEEP DIMMER | TEST | SUR |
TONE | MODE | ||
| SOURCE SELECTOR |
| |
DVD | INPUT | ||
PHONO | C D | ||
PROGRAMMABLE AREA TV/ VIDEO | |||
POWER | C H | VOLUME | |
POWER |
|
| TV/ VCR |
|
| TUNER |
|
| GROUP | PRESET | |
DISC | C D | TAPE | |
|
|
| |
SUBTITLE | DVD |
|
|
ON / OFF |
|
|
|
| PAUSE | CH SEL |
|
| / STEP |
| |
CURSOR |
|
|
|
| ENTER | LEVEL | VOLUME |
|
|
| |
|
| MUTING |
|
|
| / REMOTE |
|
|
| SPEAKER |
|
REMOTE CONTROLLER | |||
TEST TONE button
LEVEL y/u button
Level Calibration using remote controller
You can perform level calibration (channel balance setting) independ- ent of the other speaker system settings.
In the following procedure, use the remote controller unless otherwise specified.
1.Press the POWER button.
2.Press the TEST TONE button.
Press the TEST TONE button again. A test tone is output to each
speaker in the following sequence:
Left front speaker → Center speaker → Right front speaker → Right Surround speaker → Left Surround speaker → Subwoofer
(Returns to Left front speaker)
After a few seconds, the test tone automatically travels to the next speaker.
3.While the test tone is output, adjust the output level of the speaker using the LEVEL y or u button.
The test signal stays at the same speaker while adjustment is in progress.
You can change the channel to which the test tone is output by pressing the CH SEL button.
4.Repeat step 3 to adjust the output level of all speakers.
5.When the adjustment is complete, press the TEST TONE button.
The test tone output stops.
24