Sharp AL-1610 operation manual Copier TROUBLE?, Self-diagnostic function, Example

Page 32

COPIER TROUBLE?

Problem

Solution

Power is on but copying is not possible.

Lighting fixture flickers.

●Is the POWER SAVE ( ) indicator blinking?

●Is the indicator on?

●Is blinking in the copy quantity display?

●Is steadily lit in the copy quantity display?

●Is the indicator blinking?

●Is the indicator blinking?

●Is the START key ( ) indicator blinking?

●Is the same power outlet used for the lighting fixture and the copier?

Wait until warm-up is complete.

Warm-up time is approximately 35 seconds.

Copy paper is needed. See page 13, LOADING COPY PAPER.

The TD cartridge is not installed. Install the TD cartridge.

Side cover is open.

Close the front and side covers securely.

The TD cartridge must be replaced. See page

24, TD CARTRIDGE REPLACEMENT.

A misfeed has occurred. See page 28,

MISFEED REMOVAL.

Toner replenishment takes up to 2 minutes.

Wait until the START key ( ) indicator stops blinking.

Connect the copier to a power outlet which is not used for other electric appliances.

Copier trouble?

Be sure to use only genuine SHARP parts and supplies.

Please contact your SHARP service center immediately if a problem persists after checking the above.

Self-diagnostic function

An automatic self-diagnostic function is built into the copier. Should the copier malfunction, the self-diagnostic function will locate the problem and stop the copier to prevent damage. An alphanumeric code will appear in the copy quantity display.

Example

Should the copier completely stop and a letter and a number appear alternately, contact your SHARP service center immediately.

GENERAL INFORMATION

39

Image 32

Contents AL-1600 AL-1610 For Your Protection Contents Safety Precautions Main Features Part Names and Functions Part Names and Functions AUTO/MANUAL/PHOTO / / key and indicators p Alarm indicatorsInterrupt key and indicator p Power Save indicator p6START key and indicator Initial settings2Zoom keys p 3Copy ratio display key pCopier Installation Do not install your copier in areas that areGetting Started Checking Packed Components and Accessories UnpackingInstall the TD cartridge SET-UPTurn the power switch on Load copy paper SET-UPLoading Copy Paper Push the paper tray firmly back into the copierLoading Copy Paper TD Cartridge Replacement Push gently the right side of the front cover to open CoverTD Cartridge Replacement Lift the TD cartridge lock release lever and pull To remove itCartridge out until the green strap handle can be grasped By the right hand. Lift the cartridge by the handle whileDrum Cartridge Replacement Misfeed in the copier Misfeed RemovalMisfeed in the bypass tray Misfeed Removal Misfeed in the paper feed areaTurn the roller rotating knob in the direction ArrowMisfeed in the paper tray Close the side cover by pressing the handle on the coverList of user programs Setting the user programsUser Programs User Programs Auto power shut-off mode Power Save ModesPreheat mode Copying from the preheat mode Power Save ModesSetting the power save modes User Maintenance Original table and platen coverBypass tray paper feed roller Transfer chargerGently lift and pull out the paper tray and take User MaintenanceCharger cleaner out by holding the tab Problem Solution Copier TROUBLE?Example Self-diagnostic functionCopier TROUBLE? Supplies Types and sizes of copy paperSupply part numbers Supply listSupplies Genuine supplies statementProper storage Store the supplies in a location that isGently lift and pull out the paper tray until it stops Turn the power switch off and disconnect the power CordMoving Instructions Specifications Specifications Index Index Material Safety Data Sheet Ignition Temperature Special Fire Fighting ProcedureFlash Point Method Used Flammable LimitsHealth Hazards Ingredients CAS No ProportionOther Limits None required under normal use Memo Memo For users in the USA Sharp Corporation