Sharp AL-1610 Flash Point Method Used, Ignition Temperature, Flammable Limits, Nfpa Rating U.S.A

Page 41

Section 6. Physical Chemical Characteristics

Boiling / Melting Point:

Not applicable

Specific Gravity:

1.1

Vapor Pressure:

Not applicable

Solubility in Water:

Negligible

Vapor Density:

Not applicable

PH:

Not applicable

Evaporation Rate:

Not applicable

Viscosity:

Not applicable

Appearance:

Fine powder

Color:

Black

Odor:

Odorless

 

 

Section 7. Fire and Explosion Data

Flash Point (Method Used):

Not applicable

 

Ignition Temperature:

>350°C

 

Flammable Limits:

(LEL); Not applicable

(UEL); Not applicable

Extinguishing Media:

CO2, dry chemical, foam or water

 

Special Fire Fighting Procedure:

None

 

Unusual Fire and Explosion Hazard:

This material has no unusual fire or explosion hazards.

Sensitivity to Mechanical Impact:

None

 

Sensitivity to Static Charge:

None

 

Section 8. Reactivity Data

Stability:

Stable

Incompatibility (Material to Avoid):

None

Hazardous Decomposition:

CO and NOx

Hazardous Polymerization:

Will not occur.

Section 9. Precautions for Safe Handling and Use

Personal Protection Information (Respiratory, Eye Protection and Protective Glove):

Use of a dust mask is recommended when handling a large quantity of toner or during long term exposure, as with any non-toxic dust.

Engineering Control / Ventilation:

Not required.

Work / Hygienic Practice:

Inhalation should be minimized as with any non-toxic dust.

Steps to be taken in case of Spill or Leak: Sweep up or clean up with vacuum cleaner.

Waste Disposal Method:

Waste material may be dumped or incinerated under conditions

 

which meet all federal, state and local environmental regulations.

Section 10. Regulatory Information

NFPA Rating (U.S.A.):

Health = 1

Flammability = 1

Reactivity = 0

WHMIS Legislation (Canada):

This product is not a controlled product.

 

Transport Information:

This product is not a hazardous material.

 

UN No.:

None allocated.

 

 

Section 11. Other Information

References: IARC (1996) IARC Monographs on the Evaluation of the Carcinogenic Risk of Chemicals to Humans, Vol. 65, Printing Process and Printing inks, Carbon Black and Some Nitro Compounds, Lyon, pp- 149-261

H. Muhle, B. Bellmann, O. Creutzenberg, C. Dasenbrock, H. Ernst, R. Kilpper, J. C. MacKenzie, P. Morrow, U. Mohr, S. Takenaka, and R. Mermelstein (1991) Pulmonary Response to Toner upon Chronic Inhalation Exposure in Rats. Fundamental and Applied Toxicology 17, pp. 280-299

48

Page 40 Page 42
Image 41
Page 40 Page 42
Contents AL-1600 AL-1610 For Your Protection Contents Safety Precautions Main Features Part Names and Functions Part Names and Functions Alarm indicators AUTO/MANUAL/PHOTO / / key and indicators pInterrupt key and indicator p Power Save indicator pInitial settings 6START key and indicator2Zoom keys p 3Copy ratio display key pDo not install your copier in areas that are Copier InstallationGetting Started Unpacking Checking Packed Components and AccessoriesSET-UP Install the TD cartridgeSET-UP Turn the power switch on Load copy paperPush the paper tray firmly back into the copier Loading Copy PaperLoading Copy Paper Push gently the right side of the front cover to open Cover TD Cartridge ReplacementTD Cartridge Replacement To remove it Lift the TD cartridge lock release lever and pullCartridge out until the green strap handle can be grasped By the right hand. Lift the cartridge by the handle whileDrum Cartridge Replacement Misfeed in the copier Misfeed RemovalMisfeed in the bypass tray Misfeed in the paper feed area Misfeed RemovalArrow Turn the roller rotating knob in the directionClose the side cover by pressing the handle on the cover Misfeed in the paper trayList of user programs Setting the user programsUser Programs User Programs Auto power shut-off mode Power Save ModesPreheat mode Copying from the preheat mode Power Save ModesSetting the power save modes Original table and platen cover User MaintenanceBypass tray paper feed roller Transfer chargerGently lift and pull out the paper tray and take User MaintenanceCharger cleaner out by holding the tab Copier TROUBLE? Problem SolutionExample Self-diagnostic functionCopier TROUBLE? Types and sizes of copy paper SuppliesSupply part numbers Supply listGenuine supplies statement SuppliesProper storage Store the supplies in a location that isGently lift and pull out the paper tray until it stops Turn the power switch off and disconnect the power CordMoving Instructions Specifications Specifications Index Index Material Safety Data Sheet Special Fire Fighting Procedure Ignition TemperatureFlash Point Method Used Flammable LimitsHealth Hazards Ingredients CAS No ProportionOther Limits None required under normal use Memo Memo For users in the USA Sharp Corporation
Top Page Image Contents