Sharp AL-1610 operation manual Supplies, Genuine supplies statement, Proper storage

Page 34

SUPPLIES

Genuine supplies statement

Standard supplies for this copier that are to be replaced by the user are copy paper, TD cartridge, and drum cartridge.

For best copying results, be sure to use only SHARP Genuine Supplies which are designed, engineered and tested to maximize the life and performance of SHARP copiers. Look for the Genuine Supplies label on the TD cartridge and drum cartridge.

GENUINE SUPPLIES

Proper storage

1.Store the supplies in a location that is:

●clean and dry,

●at a stable temperature,

●not exposed to direct sunlight.

2.Store copy paper in the wrapper and lying flat.

●Paper stored out of the wrapper or in packages standing on end may curl or get damp, resulting in paper misfeeds.

Supplies GENERAL INFORMATION

41

Image 34

Contents AL-1600 AL-1610 For Your Protection Contents Safety Precautions Main Features Part Names and Functions Part Names and Functions Interrupt key and indicator p AUTO/MANUAL/PHOTO / / key and indicators pAlarm indicators Power Save indicator p2Zoom keys p 6START key and indicatorInitial settings 3Copy ratio display key pCopier Installation Do not install your copier in areas that areGetting Started Checking Packed Components and Accessories UnpackingInstall the TD cartridge SET-UPTurn the power switch on Load copy paper SET-UPLoading Copy Paper Push the paper tray firmly back into the copierLoading Copy Paper TD Cartridge Replacement Push gently the right side of the front cover to open CoverTD Cartridge Replacement Cartridge out until the green strap handle can be grasped Lift the TD cartridge lock release lever and pullTo remove it By the right hand. Lift the cartridge by the handle whileDrum Cartridge Replacement Misfeed in the bypass tray Misfeed RemovalMisfeed in the copier Misfeed Removal Misfeed in the paper feed areaTurn the roller rotating knob in the direction ArrowMisfeed in the paper tray Close the side cover by pressing the handle on the coverUser Programs Setting the user programsList of user programs User Programs Preheat mode Power Save ModesAuto power shut-off mode Setting the power save modes Power Save ModesCopying from the preheat mode Bypass tray paper feed roller User MaintenanceOriginal table and platen cover Transfer chargerCharger cleaner out by holding the tab User MaintenanceGently lift and pull out the paper tray and take Problem Solution Copier TROUBLE?Copier TROUBLE? Self-diagnostic functionExample Supply part numbers SuppliesTypes and sizes of copy paper Supply listProper storage SuppliesGenuine supplies statement Store the supplies in a location that isMoving Instructions Turn the power switch off and disconnect the power CordGently lift and pull out the paper tray until it stops Specifications Specifications Index Index Material Safety Data Sheet Flash Point Method Used Ignition TemperatureSpecial Fire Fighting Procedure Flammable LimitsOther Limits Ingredients CAS No ProportionHealth Hazards None required under normal use Memo Memo For users in the USA Sharp Corporation