Profile series with Codec C60 | Administrator Guide |
Contentsontents
IntroductiIntroduction
GetGettinging startstarted
AboutAbout tthe menuss
| The setSettingsings menumenu |
| TheTheSSettingsttingsSe ti Librarylibrarylibrary |
| Camerasa eras |
|
|
|
|
|
|
|
|
AppenAppendicesic
ContactContact us
The Audio settings, continued...
Audio SoundsAndAlerts RingVolume:
<0..100>
Sets the ring tone
Example: Audio SoundsAndAlerts RingVolume: 50
Audio Volume:
<0..100>
Sets the volume level
Example: Audio Volume: 70
The Camera settings
Cameras Camera [1..
7] Backlight:
<On/Off>
Backlight is used to compensate for lights shining directly at the camera (usually the sun entering the window) to avoid a too dark image from the room. Addresses the specific camera.
On: Set to On to turn on the backlight compensation.
Off: Set to Off to turn the backlight compensation off.
Example: Cameras Camera 1 Backlight: Off
Cameras Camera [1..
7] Brightness Level:
<1..31>
Define the Brightness Level for the camera. Requires the Brightness Mode to be set to manual. Addresses the specific camera.
The Camera settings, continued...
Cameras Camera [1..
7] Flip:
<On/Off>
Applies to cameras which supports Flip mode. Enables the video on screen to be flipped upside down. Addresses the specific camera. Since TANDBERG PrecisionHD 1080p camera
On: When set to On the video on screen is flipped. This setting is used with cameras that can be mounted upside down, but cannot auto detect that the camera is mounted upside down.
Off: Set to Off to display the video on screen the normal way.
Example: Cameras Camera 1 Flip: Off
Cameras Camera [1..
7] Focus Mode:
<Auto/Manual>
Determines whether the camera should be in auto focus or manual focus mode. Addresses the specific camera.
Auto: When set to Auto the focus will be updated throughout the call. When moving the camera, the system will use auto focus for a few seconds to set the right focus of the new camera position. After a few seconds auto focus is turned off to prevent continuous focus adjustments of the camera.
Manual: If set to Manual the focus is adjusted manually.
Example: Cameras Camera 1 Focus Mode: Auto
Cameras Camera [1..
7] Gamma Level:
<0..7>
By setting the Gamma Level you can select which gamma correction table to use. This setting may be useful in difficult lighting conditions, where changes to the the brightness setting does not provide satisfactory results. Requires the Gamma Mode to be set to Manual. Addresses the specific camera.
Range:
Example: Cameras Camera 1 Gamma Level: 0
Range:
Example: Cameras Camera 1 Brightness Level: 1
Cameras Camera [1..
7] Brightness Mode:
<Auto/Manual>
Define whether to control the camera brightness manually or to have it automatically adjusted by the system. Addresses the specific camera.
Auto: When set to Auto, the camera brightness is automatically set by the system.
Manual: Set to Manual to enable manual control of the camera brightness, e.g. the level of the brightness level setting will be used for the camera.
Example: Cameras Camera 1 Brightness Mode: Auto
Cameras Camera [1..
7] Gamma Mode:
<Auto/Manual>
Applies to cameras which supports Gamma mode. The Gamma Mode setting enables for gamma corrections. Gamma describes the nonlinear relationship between image pixels and monitor brightness. Addresses the specific camera. The TANDBERG PrecisionHD 1080p camera do not need Gamma Mode. The TANDBERG PrecisionHD 720p camera do support Gamma Mode.
Auto: Auto is the default and the recommended setting.
Manual: In severe light conditions, you may switch mode to manual and specify explicitly which gamma table to use by setting the Gamma Level.
Example: Cameras Camera 1 Gamma Mode: Auto
30 |