Profile series with Codec C60 | Administrator Guide |
Contentsontents
IntroductiIntroduction
GetGettinging startstarted
AboutAbout tthe menuss
The setSettingsings menumenu
TheS ttingsSettingsLibrarylibrary
Camerasa eras
AppendicesAp icices
ContactContact us
TANDBERG DNAM for Profile 42”/52”
The TANDBERG DNAM – Digital Natural Audio Module – is built on two specially designed and separate modules, the amplifier and the loudspeaker cabinet.
The DNAM Loudspeaker Cabinet
•
•Frequency range 50Hz - 20kHz
•2 x 100 mm low- and midrange loudspeaker 8 Ohms nominal, excellent quality (SEAS Prestige series)
•1 x 25mm dome tweeter, 6 ohms nominal, excellent quality
•Active crossover filtered audio signals received from DNAM amplifier
•Long time max power 70 Watt on all loudspeakers
•Enclosed MDF loudspeaker cabinet
Integrated Left / Right Stereo Loudspeaker
Stereo Loudspeaker System, each side has:
•1 x 90 mm fullrange loudspeaker, 8 Ohms nominal, excellent quality
•Frequency range 70 Hz - 20 kHz
•Enclosed MDF Loudspeaker cabinet
DNAM Loudspeaker cabinet
DNAM Amplifier
Fuse
Multiaccess Audio
In / Out 
Audio In 
(RCA)
Audio Loop Out (RCA)
Power socket
Audio Stereo Out (XLR)
Audio Differential In (XLR)
The DNAM Amplifier
•3 x 50W continuous average Center Output Power (load specified by DNAM Center Loudspeakers)
•2 x 50W continuous average Stereo Output Power (load specified by DNAM Stereo Loudspeakers)
•Full dynamic range for audio
•Digital Signal Processing and Filtering on all channels for best audio detail clarity
•Digital Crossover Filtering on center channels
•In/out:
•Audio In - SPDIF (stereo) or Analog (mono), using the same connector.
•Audio Differential In - (female XLR pinout: 1 - GND, 2 – Signal (+), 3 – Signal
•Audio Loop Out - line out directly from the input, always analog even with SPDIF in.
•Audio Stereo Out - (male XLR, common GND configuration)
•Fuse 2A 250V Slow, 5 x 20mm, Littelfuse type 215002. Push and twist
70 |