Sharp XR-50S Turn the computer on 8. Turn the power off, INPUT list, On the, Easy Start, Input

On the remote

control

_P. 28

6. Select the Input mode

Press INPUT P/R to display the INPUT list. Use INPUT P/R to select the Input mode, and use O/Q to select the audio input terminal.

On the remote control

Shrinks

lower side.

Shrinks

upper side.

(When “Setup Guide” is set to “On”. See page 48.)

2 Follow the steps in the Setup Guide and adjust the focus, height (angle) and picture size.

3 After adjusting the focus, height (angle) and picture size, press ENTER to finish the Setup Guide.

_P. 26

5. Correct trapezoidal distortion

Correcting trapezoidal distortion using Keystone Correction.

After the projector turns on, the Setup Guide appears.

1

4. Adjust the projected image with the Setup Guide

Easy Start

On the	INPUT list		On the
projector	INPUT	Audio	projector
	COMPUTER

SS-VIDEO

On the remote

control

V VIDEO

_P. 29

7.Turn the computer on

8.Turn the power off

Press STANDBY/ON on the projector or STANDBY on the remote control, and then press the button again while the confirmation message is displayed to put the projector into Standby mode.

On-screen display

On the	On the remote
projector	control

_P. 25

17