Sharp XR-55X, XR-50S Signal Adjustment SIG-ADJ Menu, Signal Type Setting, Resolution Setting

Signal Adjustment (“SIG-ADJ” Menu)

Menu operation n Page 39

	Pict.	SIG-ADJ	SCR PRJ1 PRJ2
	Clock		0
1	Phase		0
	H-Pos		0
	V-Pos		0
	Reset
2	Resolution		1024 x 768
3	Signal Type		Auto
4	Video System		Auto
5	Video Setup		0 IRE

6Signal Info 1024 x 768

H	48.3 kHz / V	60.0 Hz
SEL./ADJ.	ENTER	END

1Adjusting the Computer Image

If the optimum image cannot be obtained with Auto Sync adjustment, use the SIG-ADJ function.

Selectable	Description
items
Clock	Adjusts vertical noise.
Phase	Adjusts horizontal noise (similar to
	tracking on your VCR).
H-Pos	Centers the on-screen image by
	moving it to the left or right.
V-Pos	Centers the on-screen image by
	moving it up or down.

3 Signal Type Setting

This function allows you to select the input signal type RGB or Component for COMPUTER/ COMPONENT.

Selectable	Description
items
Auto	Input signals are automatically
	recognized as RGB or component.
RGB	Set when RGB signals are received.
YPbPr	Set when Component signals are
	received.

Note

•To reset all adjustment items, select “Reset” and press ENTER.

•The adjustable range of “H-Pos” (H-Position) and “V-Pos” (V-Position) may vary depending on the screen resolution of the computer.

2 Resolution Setting

Ordinarily, the type of input signal is detected and the correct Resolution mode is automatically selected. However, for some signals, the optimal Resolution mode in “Resolution” may need to be selected to match the computer display mode.

Note

•See “Checking the Input Signal” on page 45 for information on the currently selected input signal.

44