Runco VX-33D Connections to the VX-33d and DHD Controller, Adjusting the Projection, Angle

Installation

Note	Use only the Runco-approved ceiling mount kit designed for your
	projector. Install the mount kit according to the instructions
	provided with it.
The projector can also be inverted and placed in an enclosure above and behind the
viewing area. Install four feet on the inside bottom surface of the enclosure on which the
projector can rest. A variety of materials can be used for this purpose (for example, rubber
crutch tips or turntable feet).
If the VX-33d is ceiling-mounted and the screen is significantly lower than the projector,		Adjusting the Projection
you can tilt the projector at a slight angle by adjusting the ceiling mount.		Angle

If you do this, you may need to shift the image using the on-screen display (OSD) controls, to compensate. For detailed instructions, refer to Using the On-Screen Menus on page 47.

Proceed as follows to connect the DHD Controller to the VX-33d, your video sources, external controller(s) – if present – and AC power.

When connecting your equipment:

•Turn off all equipment before making any connections.

•Use the correct signal cables for each source.

•Ensure that the cables are securely connected. Tighten the thumbscrews on connectors that have them.

To access the connector panel, pull firmly on the cable access cover to open it.

The VX-33d is designed to receive only digital input signals directly from the companion DHD Controller/Processor. All signal sources should be connected to the appropriate inputs on the rear panel of the controller. The signal from the controller is then output to the VX-33d projector through a DVI-DL (dual-link) cable.

You CANNOT connect a signal source with DVI output directly to

Note the VX-33d. It MUST be routed through the DHD Controller for proper operation.

3.7

Connections to the VX-33d and DHD Controller

Connector Panel Access

Connecting the DHD Controller to the VX-33d

Runco VX-33d Installation/Operation Manual 29