Runco VX-33D operation manual Turning on the Power, Adjusting the Picture Orientation

Installation

1.Turn on your source components.

2.Turn on the main power switch at the rear of the DHD Controller.

3.If this is an AutoScope-equipped projector, turn on the main power switch at the rear of the AutoScope lens motor. The lens motor power switch is located next to the AC input (see Figure 3-17).

4.Press the ON button on the remote control – or the SOFT PWR button on the DHD Controller front panel – to turn on the system. The vacuum fluorescent display on the DHD Controller front panel briefly displays “Starting Display.”

5.When the projector is ready for use (after about 20 seconds), the RUN LED on the DHD Controller front panel lights solid blue. The fluorescent display indicates the current input source, aspect ratio and input resolution; for example:

Current Input Source

3.8

Turning on the Power

VX-33d Component RCA

16:9480I

Aspect Ratio Input Resolution

By default, the VX-33d is configured for a “floor/front” installation, in which the projector is installed upright and in front of the screen. If it is installed behind the screen and/or inverted, you must change the picture orientation. To do this:

1.Press MENU.

2.Select Service from the Main Menu and enter the Service Menu passcode.

3.Select Display Device from the Service Menu.

4.Select Installation from the Display Device menu.

5.Choose Floor Rear, Ceiling Front or Ceiling Rear, to match the installation method.

You must enter a passcode to access the Service menu.

Note

3.9

Adjusting the Picture Orientation

Runco VX-33d Installation/Operation Manual 39