Vizio CCU-11B manual Functions Which Require Additional Units, Unit Model No Remarks Function

Page 3

1.INTRODUCTION

This manual forms part of the Installation Manual for TOA INTERCOM SYSTEM EXES-1000.

You may add to the CCU-11B to your TOA INTERCOM SYSTEM EXES-1000, according to your specific needs, to obtain various other functions.

Correct operation of these additional functions are not

available by only connection of the additional equip-

ments/devices.

Provision of such additional functions requires the followings:

(1)Connection of the additional equipment, as required,

(2)Selection of functions which satisfy your needs and setting up these functions in the respective equipment.

For (1) Connections of Equipment, etc., refer to Manual of Installation Hand Book of EXES-1000 (EX-110) Exchange.

This "Installation Hand Book of CCU-11B" deals prin- cipally with (2) selection of functions and setting up of respective equipment.

There are certain minimum installation requirements to be met even though you may not need many additional functions or additional equipment, it is still necessary to

read "4. Initial CCU-11B Set Up (Page 4.)". When you may use only some of the additional functions or equipments, it is not necessary to read instructions on unrequired functions. Make sure, however, that careful study of the necessary parts of this booklet should be done before proceeding further.

EXES-1000 Installation Hand Book

EXES-1000 (EX-110)

EXES-1000 (CCU-11B)

Installation Handbook of Exchange.

Installation Handbook

or

(133-21-012-7A)

EXES-1000 Installation Handbook

 

2.FUNCTIONS WHICH REQUIRE ADDITIONAL UNITS

Functions of CCU-11B which require either the addition of specific units or processing in existing units are as men- tioned below.

Additional Equip-

Unit Model No.

Remarks

Function

ment Required

 

 

Talk-Back from

TKU-11

Optional amplifier (10W max.) may be

Talk-Back Unit

required depending on application.

paging speaker

 

— 2 —

Image 3
Contents TOA EXES-1000 Intercom System Contents Unit Model No Remarks Function Functions Which Require Additional UnitsProgram Switch for No Programming Precautions for Installation of CCU-11BIs Executive Priority necessary? Initial CCU-11B SET UPFirst installation? Yes Confirmation toneOFF Continuously called station number Station no Programming for Each FunctionAscertain holding tone Sub-station Number Sub-station Number Opening Then touch dial Remote Control Relays RY1 & RY2 on CCU-11BSW-A-3 OFF SW-A-3 on SW-B-2 OFFConnections Station No Programming List for FunctionsKOBE, Japan