Sharp PG-C20XU operation manual Connecting an amplifier and other audio components, Amplifier

Connecting the Projector

Connecting a video source (DTV decoder or DVD player) using the 15-pin input

			1 Connect one end of the HD-15/RCA cable or the HD-
			15-RGB cable to the COMPUTER INPUT 1 port on the
			projector.
			2 Connect the other end to the corresponding terminals
			on the video source.
			3 To use the built-in audio system, connect one end of
			the audio cable to AUDIO INPUT 1 terminal on the
			projector.
			Connect the other end to the audio output terminals on
			the video source.
			• The projector can only accept 480P DTV signals through
			COMPUTER INPUT 1 terminal. Therefore, set your DTV to RGB
			monitor output.
			• The image quality may become lower depending on DTV signal
			compatibility.
		HD-15/RCA cable (sold separately)
Projector			2 To video output terminals	DTV decoder
RS-232C	INPUT 1	OUTPUT (INPUT 1)		or
AUDIO	COMPUTER	HD-15-RGB cable (sold separately)
		AUDIO COMPUTER

DVD player

2 To video output terminals

Audio cable (sold separately)

3 To audio output terminals

Connecting an amplifier and other audio components

1 Connect one end of the audio cable to the AUDIO OUTPUT terminal for INPUT 1 on the projector.

2 Connect the other end to the corresponding terminals on the audio components.

CAUTION

• Always turn off the projector while connecting to audio components, in order to protect both the projector and the components being connected.

• By using external audio components, the volume can be amplified for better sound.

• The AUDIO OUTPUT terminal for INPUT 1 allows you to output audio to audio components from the AUDIO INPUT 1 terminal connected to audiovisual equipment.

Projector

	INPUT 1	OUTPUT (INPUT 1)
O	COMPUTER	AUDIO	COMPUTER
			Audio cable (sold separately)

To audio input terminals

Amplifier

Setup & Connections

E-14