Operation
Operation
Basic Operations
Maintenance indicators
ON/OFF | LAMP | |
POWER | ||
| ||
| TEMP. | |
KEYSTONE |
|
Projector | Remote control | ||
| ON/OFF | LAMP |
|
POWER |
| 2 | |
|
| ||
|
|
| |
|
| TEMP. |
|
| KEYSTONE |
| |
INPUT |
| AUTO SYNC |
|
BACK |
| ENTER | MENU |
Maintenance indicators
1Make the necessary connections before pro- ceeding. Connect the power cord to a wall outlet. The POWER indicator illuminates red and the projector enters standby mode.
•If the side filter cover is not securely installed, the POWER indicator flashes.
2Press ON/OFF on the projector or POWER on the remote control for over one second.
•The flashing green LAMP REPLACEMENT indicator shows that the lamp is warming up. Wait until the indicator stops flashing before operating the projector.
•The power cannot be turned off for one minute after the power is turned on.
•If the power is turned off and then immediately turned on again, it may take a short while before the lamp turns on.
•After the projector is unpacked and turned on for the first time, a slight odor may be emitted from the exhaust vent. This odor will soon disappear with use.
•Do not press any buttons before the startup image disappears. Before “Adjusting The Image” appears, only ON/OFF or POWER is available.
POWER
ON/OFF LAMP
TEMP.
When the power is on, the LAMP REPLACEMENT indicator lights indicating the status of the lamp.
Green: Lamp is ready.
Flashing green: Warming up.
KEYSTONE
Red: Change the lamp.