Sim2 Multimedia SVD 800 HD Horizontal and vertical frequencies, How to store a new input signal

SVD 800 HD

Press or . Select the right ratio from among: N (Normal), S (Small), L (Letter box), C (Cinema), W (Wide).

Press ENTER to confirm.

The following message will appear under the table: EDIT

ASPECT RATIO.

5.8.4Horizontal and vertical frequencies

The horizontal and vertical frequencies are measured by the projector and stored in the relative memory bank each time you store a change.

If the input signal does not match the frequency stored in the memory bank the software will automatically recall the memory bank with the frequency nearest to that of the input signal, in this order: horizontal frequency, vertical frequency, aspect ratio.

If the frequencies of the input signal are different from those stored in the memory bank, the software will not recognise the frequency and, if you store settings, it will ask to create a new memory bank.

5.8.5 How to store a new input signal

Press MEMO only after the convergence adjustments have been done, the following will appear:

NEW INPUT SIGNAL

FH = XX.X KHZ FV = XX HZ

CREATE MEMORY BANK?

Fig. 82

Press ENTER and the following will appear:

Enter the label; see par. 5.8.2 page 29. Press ENTER and the following will appear:

NEW INPUT SIGNAL

CONFIRM NEW NAME: XXXXXXXX

ENTER NAME = XXXXXXXX

Fig. 84

Press ENTER. The menu will appear with the number of the bank where it is stored.

Press ESC to exit.

5.8.6 LOAD

This item on the MEMORY MANAGER menu allows the user to load and change a memory bank containing all the projector adjustments.

This is possible only if there is a match between the input frequencies and the frequencies stored in the memory bank.

Press	or	. Select LOAD, ENTER
Press	or	. Select a memory bank whose frequencies
are like the current signal.
		- MEMORY MANAGER -
		BANK	01 SIGNAL NAME				PAL
		LOAD	N	HOR VER		F	LABEL
			00	33.7	60	N	ATSC1080
		COPY	01	15.6	50	N	PAL
			02	15.7	60	N	NTSC358
			03	31.5	70	N	DOS-VGA
			04	31.5	60	N	VGA-640
		MOVE	05	31.2	60	N	31K 10HZ
			06	48.4	00	N	VESA 1024
			07	64.3	60	N	64K 60HZ
		DEL	08	71.7	76	N	UN 76HZ
			09	44.9	60	N	ATSC720P
		LOAD BANK						Fig. 85

Press ENTER.

The following message will appear under the table.

NEW INPUT SIGNAL

FH = XX.X KHZ FV = XX HZ

ENTER NAME = – – – – – – – –

RECALL A BANK FROM MEMORY

Fig. 86

If the input signal frequencies (horizontal and vertical) do not match the selected memory bank, the following message will appear under the table.

Fig. 83

FREQUENCY MUST MATCH !

Fig. 87

30