Sim2 Multimedia SVD 800 HD installation manual How to reset the adjustments Reset, Colours

5.12How to reset the adjustments (RESET)

Note: Resetting means setting all adjustment values at 50 that corresponds to zero. Starting from this value you can adjust up to 100 or down to 0.

To reset adjustments read the following instructions carefully.

If you press the RESET button when you are in the convergence setups (CONV), you will reset the convergence parameters and those of the zones of the three colours R.G.B..

If you press the RESET button when you are in the ZONE setups, you will reset the zone parameters of the three colours R.G.B.

The following table shows which parameters are reset and in which menus.

RESET	RESET PARAMETERS	COLOURS
CONV	CONVERGENCE AND ZONE	ALL
ZONE	ZONE	ALL

N.B.: After RESET, you can recall the previous values by loading the current bank from the MEMORY MA- NAGER (LOAD), if the MEMO procedure has not been carried out.

5.13How to store the convergence adjustments (MEMO)

Press MEMO, the following will appear:

PHASE

CRT = R G B

MEMORIZE ALL DATA

BANK XX XXK-XXHZ

H. VALUE = XX

Fig. 117

press ENTER, the following will appear:

PHASE

CRT = R G B

ALL DATA MEMORIZE

ON BANK XX XXK-XXHZ

H. VALUE = XX

Fig. 118

Storing has now been completed on the current memory bank. Press ESC to exit.

SVD 800 HD

ENGLISH

35