Vidikron 60 manual Audio

Page 13

CONTROLS AND FEATURES

5.AUDIO IN

Not used.

6.REMOTE

When the remote control is unable to work due to rear projection etc., the [REMOTE] terminal can be used to connect an external sensor to the projector. The external sensor is not generally sold. Check with your authorized Vidikron dealer.

7. CONTROL RS-232 IN/OUT

This is the RS-232 OUT interface-specific terminal. The projector can be controlled by a computer connected externally. More than one projector can be controlled using both the [RS-232 IN] and [RS-232 OUT] terminals.

8. Y/C

This is the input terminal for Y/C (S-Video) signals. Connect this terminal to the S-Video output terminal of a video deck, etc.

9. VIDEO

This is an input terminal for composite video signals. Connect this terminal to the composite video output terminal of a VCR, etc.

12

Image 13

Contents L a P R O J E C T O R Table of Contents » Contents of the package » The features you’ll enjoy includeIntroduction » OptionsAbout the installation place Safety PrecautionsFCC Information U.S.A. only About burning-in of the D-ILA deviceSafety Precautions Power Connection Using the screen mode switch function Cleaning the lensViewing conditions Brightness of the room Do not view the screen continually for a long timeFor Projectors, Video Processors and Controllers Limited WarrantyEffective Warranty Date » Projector Chassis Cover Controls and FeaturesTo Open the Projector Cover To Close the Projector CoverLamp Button » Control Panel on the ProjectorInput Terminal » Connector PanelRGB1 DVI RGB3Audio » Remote Control Cursor OFFPC 4x3 Button PC 16x9 ButtonENT Enter Button VID S-Video Button» Installing the Projector against the Screen Installing the ProjectorThrow Distance Chart Screen Installation» Projection Distance and Screen Size 43 Screen» Signals that can be input into the projector Connecting to Various DevicesVideo Signals Response to Decoder Responds to double density*5, high-vision signalsAllowable input signals Hdcp compatible signalConnecting to Video Devices » Connecting to DevicesRight Side of Projector Connecting to Computers Control from External Device Connecting the Power Cord Supplied Basic Operation Basic Operation Mute Pause Keystone Auto ADJ » Frequently Used Convenient FunctionsUsing the Auto Adjust function for automatic adjustments Auto Adjust functionWhen video input is selected Adjustment and Settings Using Menus» Menu Structure » When RGB input is selected » When no image signal is inputted » Menu Operation Buttons » The Procedure for Menu Operation Press the Menu button » The Menu Configuration Adjustment and Settings Using Menus Adjustment and Settings Using Menus » Setting the Aspect Ratio Setting Aspect Ratio and ResizeProject the image onto the screen Press the Menu button Select Letterbox with the cursor buttons Press the Menu button to end when adjustment is completedSelect Resize with the cursor buttons / and press Enter » Setting the ResizeSelect Letterbox with the cursor buttons When lamp time exceeds 1000 hours Replacing the Lamp for Service onlyWhen the lamp time exceeds 2000 hours When the lamp time exceeds 2010 hoursInsert the power cord into the wall outlet Resetting the Lamp Time for Service onlyTo ensure the lamp hours have been reset Command Format Command Data Format Communication SpecificationsRS-232 External Control Response Data FormatRGB3 External Control Command TableSymptom Probable Cause Solution TroubleshootingSymptom Probable Cause Solution Message Cause Contents What to do When These Messages are Displayed» About Warning Indicators Dimensions Vision Model 60 Projector Specifications