Vidikron 60 manual What to do When These Messages are Displayed, Message Cause Contents

WHAT TO DO WHEN THESE MESSAGES ARE DISPLAYED

Message	Cause (Contents)
	No device is connected to the input terminal.
	The terminal is connected but no signal is output from the connected device.
	• The selected input mode (input terminal) name is shown above the mes-
�����	sage.
��������	→ Check the input image signal source.

The frequency of the input video signal is out of range.

→Please ensure the frequency level of the input video signals is within the projector’s specifications.

�����

������������������������������������������

		When the “Lamp hours” reaches 1000 hours
		→ A message indicating “1000h” appears on the projected screen.
		• Press [EXIT] button to delete the message.
�����
	����
		When the accumulated lamp time reaches between 1900 hours to 2000
		hours,
		“Lamp replacement” message appears on the screen each time the projector
����������������		is turned on.
		• Press [EXIT] button to delete the message.
	����	→ Prepare a replacement lamp and install as quickly as possible.
		The word “Warning” appears and blinks when the accumulated lamp time
		reaches 2000 hours.
����������������		The message can be cleared by pressing the [EXIT] button. However, the
		same message will re-appear every hour.
�������		Once the projector is turned off, it cannot be turned on again if the accumulated
	����	lamp time has exceeded 2000 hours.
		When the accumulated lamp time reaches 2010 hours, the projector shuts
		down and cannot be turned on again.
		→ Replace the light-source lamp and reset the lamp hours.

46