Vidikron 60 manual Symptom Probable Cause Solution

Page 46

 

 

TROUBLESHOOTING

 

 

 

 

 

 

Symptom

Probable Cause

Solution

The upper part of the

If the input signal comes from a computer system,

Input separate sync signals for vertical sync (V)

video image bows or

is this a sync signal of composite sync (Cs) or G

and horizontal sync (H) signals

distorts

on sync type?

 

Remote control unit does

Are batteries installed correctly?

Match the polarities of batteries correctly, as

not work.

 

shown on the battery cartridge.

 

Are batteries exhausted?

Replace with new batteries.

 

Is there an obstructive object between the remote

Remove any shielding objects.

 

control unit and the remote sensor?

 

 

Is the remote control held too far from the sensor?

Use the remote control unit at a nearer point.

45

Image 46
Contents L a P R O J E C T O R Table of Contents Introduction » The features you’ll enjoy include» Contents of the package » OptionsFCC Information U.S.A. only Safety PrecautionsAbout the installation place About burning-in of the D-ILA deviceSafety Precautions Power Connection Viewing conditions Brightness of the room Cleaning the lensUsing the screen mode switch function Do not view the screen continually for a long timeLimited Warranty For Projectors, Video Processors and ControllersEffective Warranty Date To Open the Projector Cover Controls and Features» Projector Chassis Cover To Close the Projector Cover» Control Panel on the Projector Lamp ButtonRGB1 » Connector PanelInput Terminal DVI RGB3Audio » Remote Control OFF CursorENT Enter Button PC 16x9 ButtonPC 4x3 Button VID S-Video ButtonInstalling the Projector » Installing the Projector against the Screen» Projection Distance and Screen Size Screen InstallationThrow Distance Chart 43 ScreenVideo Signals Response to Decoder Connecting to Various Devices» Signals that can be input into the projector Responds to double density*5, high-vision signalsHdcp compatible signal Allowable input signalsConnecting to Video Devices » Connecting to DevicesRight Side of Projector Connecting to Computers Control from External Device Connecting the Power Cord Supplied Basic Operation Basic Operation » Frequently Used Convenient Functions Mute Pause Keystone Auto ADJAuto Adjust function Using the Auto Adjust function for automatic adjustmentsWhen video input is selected Adjustment and Settings Using Menus» Menu Structure » When RGB input is selected » When no image signal is inputted » Menu Operation Buttons » The Procedure for Menu Operation Press the Menu button » The Menu Configuration Adjustment and Settings Using Menus Adjustment and Settings Using Menus » Setting the Aspect Ratio Setting Aspect Ratio and ResizeProject the image onto the screen Press the Menu button Press the Menu button to end when adjustment is completed Select Letterbox with the cursor buttons» Setting the Resize Select Resize with the cursor buttons / and press EnterSelect Letterbox with the cursor buttons When the lamp time exceeds 2000 hours Replacing the Lamp for Service onlyWhen lamp time exceeds 1000 hours When the lamp time exceeds 2010 hoursInsert the power cord into the wall outlet Resetting the Lamp Time for Service onlyTo ensure the lamp hours have been reset RS-232 External Control Communication SpecificationsCommand Format Command Data Format Response Data FormatExternal Control Command Table RGB3Troubleshooting Symptom Probable Cause SolutionSymptom Probable Cause Solution What to do When These Messages are Displayed Message Cause Contents» About Warning Indicators Dimensions Specifications Vision Model 60 Projector